Surface chemical analysis — Scanning probe microscopy — Guideline for the method and procedure for d...
This International Standard specifies the guidelines of the method and procedure for determining the effect of temperature on atomic force microscope (AFM) nano-scale dimension measurements. The effect of temperature can be evaluated by continuously measuring the changes of the X- and Y- pitches and height of a two-dimensional (2D) calibration grating in an environmental temperature controllable…
Steel — Determination of the non-metallic inclusion content — Micrographic method
ISO 4967:2013 specifies a micrographic method of determining the non-metallic inclusions in rolled or forged steel products having a reduction ratio of at least 3 using standard diagrams. This method is widely used to assess the suitability of a steel for a given use. However, since it is difficult to achieve reproducible results owing to the influence of the test operator, even with a large…
Information security, cybersecurity and privacy protection — Information security controls based on ...
ISO/IEC 27017:2015 gives guidelines for information security controls applicable to the provision and use of cloud services by providing:
- additional implementation guidance for relevant controls specified in ISO/IEC 27002;
- additional controls with implementation guidance that specifically relate to cloud services.
This Recommendation | International Standard provides controls and…
Hot-rolled steel sections — Dimensions, sectional properties and tolerances — Part 1: Angles, channe...
This first edition as an International Standard constitues a technical revision of ISO Recommendation R 657-1:1968. ISO 657 consists of 21 parts integrating any shapes of sections. ISO 657-1 specifies dimensions of hot-rolled equal-leg angles.
Assembly tools for screws and nuts — Hand torque tools — Part 2: Requirements for calibration and de...
This document specifies the method for the calibration of hand torque tools and describes the method of calculation of measurement uncertainties for the calibration.
It also specifies the minimum requirements for a certificate of calibration to this standard for hand torque tools.
The Annex C of this document specifies the minimum requirements for the calibration of the torque measurement device…
Gas analysis — Comparison methods for determining and checking the composition of calibration gas mi...
This International Standard provides methods for
_ determining the composition of a calibration gas mixture by comparison with appropriate reference gas
mixtures,
_ calculating the uncertainty of the composition of a calibration gas mixture in relation to the known uncertainty of
the composition of the reference gas mixtures with which it was compared,
_ checking the composition attributed to a…
Road vehicles — Vehicle to grid communication interface — Part 21: Common 2nd generation network lay...
The document specifies all common test cases to be applied to and correctly handled by EVs (EVCC) and EVSEs (SECC) implementing ISO 15118-20 that are independent of a particular charging type (AC, DC, ACD, WPT charging). The document considers the use cases defined in ISO 15118-1:2019
The test system will comprise:
- A simulated SECC to verify the correct behaviour of a real EVCC
- A simulated…
Corrugated fibreboard — Determination of flat crush resistance
This International Standard specifies a method for the determination of the flat crush resistance of corrugated fibreboard used in the manufacture of shipping containers.
This International Standard is applicable to single-faced and single-wall (double-faced) corrugated fibreboard.
This International Standard is not applicable to double-wall (double-double-faced) corrugated fibreboard and to…
Water quality — Estimation of measurement uncertainty based on validation and quality control data
This International Standard specifies methods for the estimation of measurement uncertainty of chemical and
physicochemical methods in single laboratories based on validation data and analytical quality control results
obtained within the field of water analysis.
NOTE 1 The principles of the estimation of uncertainty specified in this International Standard are consistent with the
principles…
