Rechercher

ISO 17604:2015 specifies sampling methods for the detection and enumeration of microorganisms on the surface of carcasses or parts of carcasses of slaughtered meat animals. The microbiological sampling can be carried out as part of - process hygiene control (to validate and or verify process control, e.g. total counts and Enterobacteriaceae) in slaughter establishments for large mammals,…

IEC TS 63189-1:2023 covers the terms and definitions, system composition and control modes of virtual power plant (VPP). It defines the functional requirements for VPPs, including power generation forecasting, load forecasting, generation and consumption scheduling, control and management of energy storage devices and loads, coordinated optimization of distributed energy resources, status…

ISO 13164-3:2013 specifies a test method for the determination of radon-222 activity concentration in a sample of water following its transfer from the aqueous phase to the air phase by degassing and its detection. It gives recommendations for rapid measurements performed within less than 1 h. The radon-222 activity concentrations, which can be measured by this test method utilizing currently…

ISO 16639:2017 provides guidelines and performance criteria for sampling airborne radioactive substances in the workplace. Emphasis is on health protection of workers in the indoor environment. ISO 16639:2017 provides best practices and performance-based criteria for the use of air sampling devices and systems, including retrospective samplers and continuous air monitors. Specifically, this…

1 Scope 1.1 General This Standard addresses the geotechnical engineering aspects of (a) gravity-base structures; (b) fill structures; (c) fill-retention structures; and (d) pile-supported structures. Specific considerations include site investigations, general design principles, the influences of soil and natural processes on the foundation components, and the geotechnical factors that affect…

This document specifies the requirements and recommendations for the transportation of CO2 streams from the capture site to the storage facility where it is primarily stored in a geological formation or used for other purposes (e.g. for enhanced oil recovery or CO2 use). This document applies to the transportation of CO2 streams by —     rigid metallic pipelines, —     pipeline systems, —    …

ISO 10414-1:2008 provides standard procedures for determining the following characteristics of water-based drilling fluids: drilling fluid density (mud weight), viscosity and gel strength, filtration, water, oil and solids contents, sand content, methylene blue capacity, pH, alkalinity and lime content, chloride content and total hardness as calcium. ISO 10414-1:2008 provides additional test…

This document specifies a chronic test method for evaluating the habitat function of soils and determining effects of soil contaminants and substances on the reproduction of Hypoaspis aculeifer by ? mainly ? alimentary uptake. This method is applicable to soils and soil materials of unknown quality, e.g. from contaminated sites, amended soils, soils after remediation, industrial, agricultural or…

This document specifies one of the methods for evaluating the habitat function of soils and determining effects of soil contaminants and individual chemical substances on the reproduction of the oribatid mite Oppia nitens by dermal and alimentary uptake. This chronic (28-day) test is applicable to soils and soil materials of unknown quality (e.g., contaminated sites, amended soils, soils after…

This document specifies the requirements and performance test procedures for monostatic heterodyne continuous-wave (CW) Doppler lidar techniques and presents their advantages and limitations. The term "Doppler lidar" used in this document applies solely to monostatic heterodyne CW lidar systems retrieving wind measurements from the scattering of laser light by aerosols in the atmosphere…