Rechercher

1 SCOPE 1.1 This Standard sets forth minimum requirements for steel, non pressure tanks that are used for the aboveground storage of flammable and combustible liquids compatible with the material of construction and with a specific gravity not greater than 1.0. NOTE: These tanks may also be used for the storage of used oil. For tanks intended solely for the collection of used oil, refer to…

1. SCOPE 1.1 This Standard sets forth minimum requirements for steel, non-pressure tanks that are used for the aboveground storage of flammable and combustible liquids such as gasoline, fuel oil, or similar products with a relative density not greater than 1.0. NOTE: These tanks may also be used for the storage of used oil. For tanks intended solely for the collection of used oil, refer to ULC-…

Le présent document fournit des recommandations pour l'échantillonnage des sols: — des sites naturels et quasi naturels; — des zones arborées naturelles, incluant les forêts et les bois; — des zones utilisées pour l'agriculture (terres arables et pâturages); — des zones utilisées pour l'horticulture (y compris les jardins privés et les jardins…

This document specifies the essential characteristics of a test track surface intended to be used for measuring rolling sound emission of vehicles and their tyres. The surface design given in this document —    produces consistent levels of tyre or road sound emission under a wide range of operating conditions including those appropriate to vehicle sound testing, —    minimizes inter-site…

This document specifies a test method for atmospheric corrosion measurements, using two-electrode electrochemical sensors. It is applicable to measurements of the corrosion rate of uncoupled metal surfaces (i.e. "free" corrosion rate), galvanic corrosion rate, conductance of thin film solutions and barrier properties of organic coatings. It specifies electrochemical sensors that are…

Le présent document fournit des recommandations pour la conception et l'exécution d'investigations préliminaires comprenant des études sur documents et une reconnaissance du site, et, le cas échéant, une appréciation préliminaire du risque. Il est applicable lorsque des activités d'échantillonnage ou des investigations doivent être effectuées pour déterminer la qualité du sol.

ISO 18400-103:2017 gives guidelines for: - identification of hazards that could be encountered during a site investigation and when collecting samples of soil and other ground material, including hazards that are intrinsic in the sampling operation (e.g. physical hazards) in addition to the hazards that might arise, e.g. from contamination with chemicals or biological agents; - measures…

ISO 10844:2014 specifies the essential characteristics of a test surface intended to be used for measuring vehicle and tyre or road noise emissions. The surface design given in ISO 10844:2014 produces consistent levels of tyre or road sound emission under a wide range of operating conditions including those appropriate to vehicle sound testing, minimizes inter-site variation, provides minor…

IEC/TS 62600-100:2012(E) provides a method for assessing the electrical power production performance of a Wave Energy Converter (WEC), based on the performance at a testing site. Provides a systematic method which includes: - measurement of WEC power output in a range of sea states; - WEC power matrix development; - an agreed framework for reporting the results of power and wave measurements…

ISO 20806:2009 specifies procedures to be adopted when balancing medium and large rotors installed in their own bearings on site. It addresses the conditions under which it is appropriate to undertake in-situ balancing, the instrumentation required, the safety implications and the requirements for reporting and maintaining records. ISO 20806:2009 can be used as a basis for a contract to undertake…