Rechercher

This document outlines the criteria for evaluating the available and the required flow rate of geosynthetics in various situations, provides a summary of the available laboratory testing, and lists the safety factors and reduction factors that can be applied to the parameters when designing using geosynthetics for drainage systems.

This document specifies requirements for in vitro measuring systems for self-monitoring of vitamin-K antagonist oral anticoagulation therapy, including performance, quality assurance and user training and procedures for the validation of performance by the intended users under actual and simulated conditions of use. This document applies solely to prothrombin time measuring systems used by lay…

This document specifies an oven-drying method for the determination of the dry matter content in suspensions of cellulosic nanomaterials. The procedure is applicable to cellulosic nanomaterial suspensions which do not contain any appreciable quantities of materials other than water that are volatile at the temperature of 105 °C ± 2 °C. It is used, for example, in the case of cellulosic…

1 Scope This document specifies a method for the determination of water sorption in a laboratory setting and provides a measure for how the durability is impacted as a result of immersion in water. Post-immersion durability reduction is calculated as the difference between the durability of the as-received sample and the durability of the wetted product.

This document specifies a laboratory method for determining the flash-ignition temperature and spontaneous-ignition temperature of plastics using a hot-air furnace. It is one of a number of methods in use for evaluating the reaction of plastics to the effects of ignition sources. NOTE       Information on additional ignition methods can be found in ISO 10093. This method does not give a direct…

This document specifies the requirements for the laboratory testing of the resistivity of specially prepared specimens of plastics rendered conductive by the inclusion of conductive fillers or suitable modification of the structure. The test is applicable to materials of resistivity less than 106 Ω⋅cm (104 Ω⋅m). The result is not strictly a volume resistivity, because of surface conduction, but…

This document specifies laboratory test procedures to determine the static and low-frequency dynamic stiffness of rail pads, baseplate pads and complete rail fastening assemblies.

This document specifies a laboratory method for measuring the vibration at the handle of fastener driving tools. It is a type test procedure for establishing the vibration value on the handle of a hand-held power tool operating under a specified load. This document is applicable to fastener driving tools driven pneumatically or by other means, using nails, staples or pins. This document is…

This document specifies laboratory exposure procedures for determining the effects of cyclic movement and artificial weathering on cured, elastic weatherproofing joint sealants (one- or multi-component).