Rechercher

Le présent document spécifie les méthodes, les tolérances et les critères d'acceptation permettant de vérifier les performances des équipements complets de contrôle par ultrasons (c'est-à-dire l'appareil, les traducteurs et les câbles connectés), en utilisant des blocs d'étalonnage normalisés appropriés. Ces méthodes sont spécifiquement destinées aux équipements de contrôle…

This document specifies a series of preparation grades for steel surfaces after removal/partial removal of water-soluble contaminants, rust, previous paint coatings and other foreign matter by high-pressure water jetting. The various grades are defined by written descriptions together with photographs that are representative examples within the tolerances for each grade as described in words.…

This document specifies requirements for the commissioning of lighting systems in buildings to meet design specifications. This document presents details of the commissioning of lighting systems without focusing on the technical characteristics of specific components. This document can be applied to new installations of non-residential buildings and public spaces of multi-residence buildings.…

1 Scope 1.1 This Standard applies to complete wind turbine electrical systems and associated electrical equipment intended for connection at not more than 46 kV and intended for use in accordance with the Canadian Electrical Code, Part I. Products covered by the scope of this Standard are subject to the requirements of CSA C22.2 No. 0. 1.2 This Standard applies to wind turbines of all sizes…

Scope Replacement: This document applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of VENTILATORY SUPPORT EQUIPMENT, as defined in 201.3.205, for VENTILATORY IMPAIRMENT, as defined in 201.3.202, hereafter also referred to as ME EQUIPMENT, in combination with its ACCESSORIES: — intended for use in the HOME HEALTHCARE ENVIRONMENT; — intended for use by a LAY OPERATOR; and — intended for…

Scope Replacement: This document applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of VENTILATORY SUPPORT EQUIPMENT, as defined in 201.3.205, for VENTILATORY INSUFFICIENCY, as defined in 201.3.204, hereafter also referred to as ME EQUIPMENT, in combination with its ACCESSORIES: — intended for use in the HOME HEALTHCARE ENVIRONMENT; — intended for use by a LAY OPERATOR; — intended for…

1 Scope 1.1 This Standard applies to cord-connected and permanently connected electrically heated pottery kilns for use on nominal system voltages of 600 V or less, designed to be used in accordance with the rules of CSA C22.1, Canadian Electrical Code, Part I. 1.2 This Standard does not apply to electrical equipment employing high-frequency currents or industrial heating equipment. 1.3 In…

1 Scope 1.1 This Standard applies to extra-low-voltage landscape lighting systems and associated components that are intended for cord-connected, direct plug-in, or permanent connection to a branch circuit of not more than 150 volts-to-ground in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard only covers extra-low-voltage landscape lighting systems where the maximum…

This document specifies the physical and mechanical properties of pipes made from unplasticized polyamide (PA-U) in accordance with ISO 16486-1, intended to be buried and used for the supply of gaseous fuels. It also specifies the test parameters for the test methods to which it refers. The ISO 16486 series of standards is applicable to PA-U piping systems, the components of which are connected…