Rechercher

This document applies only to dimethyl-ether refuelling connectors with a pressure-equalizing port, hereinafter referred to as devices, constructed entirely of new, unused parts and materials. Dimethyl-ether refuelling connectors with a pressure-equalizing port consist of the following components, as applicable: a)       nozzle with a pressure-equalizing port, The refuelling nozzle and pressure-…

Scope 1.1 This Standard sets forth requirements for video and thermal image fire detectors and accessories for non-dwelling units, including mechanical guards to be employed in indoor locations (for video and thermal) and outdoor (for thermal) in accordance with the following: a) In the United States: 1) National Fire Alarm and Signaling Code, NFPA 72; 2) National Electrical Code, NFPA 70…

This document specifies methods for testing the immunity of passenger cars and commercial vehicles to electromagnetic disturbances from on-board transmitters connected to an external antenna and portable transmitters with integral antennas, regardless of the vehicle propulsion system (e.g. spark ignition engine, diesel engine, electric motor).

This document specifies requirements for compressed air foam systems (CAFS) in which foam concentrate and compressed air are continuously added to the water being discharged from the fire-fighting pump. This document is applicable to CAFS that can be permanently installed in fire-fighting vehicles, or that are transportable or mobile. This document specifies requirements for CAFS which are used…

This document in combination with ISO 5474-1 specifies requirements for conductive power transfer using alternating current (AC) with a voltage up to 1 000 V a.c. between electrically-propelled road vehicles and external electric circuits. NOTE          External electric circuits are not part of the vehicle. This document provides requirements for conductive charging in modes 2, 3 according to…

IEC TR 63323:2024 deals with a new proposal for an SC adaptor connector which includes a flexible retaining element on its top surface, compared to the SC standard adaptor. With this solution, when the SC plug connector is in place, any accidental disconnection is difficult, as it employs an external tool or a particular unlocking manoeuvre. This new adaptor is intended primarily for the home…

This document specifies the test method for determining the resistance of chemical protective clothing to penetration by sprays of liquid chemicals at two different levels of intensity: a)       Method A: low-level spray test. This is applicable to clothing that covers the full body surface and is intended to be worn when there is a potential risk of exposure to small quantities of spray or…

This document specifies test conditions and test procedures for determining the performance characteristics of air to water heat pumps for space heating and/or space cooling with electrically driven compressors with or without supplementary heater. The purpose of this document is to rate the performance of the air to water heat pumps for space heating and/or space cooling. In the case of air to…

Scope 1.1 These requirements cover hose and hose assemblies, including vapor recovery hose and assemblies, for use on dispensing devices for motor fuels. A flammable liquid hose assembly consists of flexible hose and fittings suitable for attachment to motor fuel dispensing equipment. Motor fuels, as defined by these requirements, include one or more of the fuels described in 1.3. 1.2 Hose…

Scope 1.1 These requirements cover emergency breakaway fittings, swivel connectors and pipe-connecting fittings of the threadless compression type. Connectors and fittings covered by these requirements are intended only for the following services. 1.2 Emergency breakaway fittings, swivel connectors and pipe-connecting fittings for gasoline/ethanol blends with nominal ethanol concentrations…