Rechercher

1 Scope 1.1 This standard applies to visual signaling devices intended for indoor and/or outdoor installation: a) In Canada, in accordance with CSA C22.1, Canadian Electrical Code, Part I, Safety Standard for Electrical Installations; and with CAN/ULC S524, Standard for Installation of Fire Alarm Systems. Refer to CAN/ULC S525 Audible Signaling Devices for Fire Alarm and Signaling Systems,…

1.1 This Standard applies to newly produced household cooking gas appliances (see Clause 3, Definitions), hereinafter referred to as units or appliances, constructed entirely of new, unused parts and materials. These appliances may be floor supported or built-in. 1.2 This Standard applies to household cooking gas appliances: a) for use with natural gas; b) for use with manufactured gas; c…

1 Scope [In the second paragraph, replace “250 V for single-phase appliances and 480 V for other appliances” with “750 V”] [Replace the second sentence of the third paragraph with the following] All safety aspects are covered when the appliance also complies with the relevant standard for the fuelburning appliance. At the time of this publication, the relevant standards for oil fuel-burning…

1.1 This Standard sets forth requirements for smoke detectors and accessories, including mechanical guards to be employed in ordinary indoor locations in accordance with the following: In the United States: a) National Fire Alarm and Signaling Code, NFPA 72. In Canada: b) Standard for the Installation of Fire Alarm Systems, CAN/ULC-S524; c) National Building Code of Canada; and d) National…

1.1 This Standard applies to wall and ceiling-mounted track lighting systems, rated 347 V, 40 A max, incorporating incandescent, fluorescent, light emitting diodes and high-intensity discharge lighting sources, intended to be installed in non-hazardous, dry locations in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard applies to plug- and cord-connected track lighting…

IEC 61935-1:2015(E) specifies reference measurement procedures for cabling parameters and the requirements for field tester accuracy to measure cabling parameters identified in ISO/IEC 11801. References in this standard to ISO/IEC 11801 mean ISO/IEC 11801 or equivalent cabling standards. This International Standard applies when the cable assemblies are constructed of cables complying with the IEC…

IEC TS 62257-6:2015(E) describes the various rules to be applied for acceptance, operation, maintenance and replacement of decentralized rural electrification systems which are designed to supply electric power for sites which are not connected to a large interconnected system, or a national grid, in order to meet basic needs. This technical specification proposes a methodology to achieve the…

IEC TS 62257-5:2015(E) specifies the general requirements for the protection of persons and equipment against electrical hazards to be applied in decentralised rural electrification systems. Requirements dealing with protection against electric shock are based on basic rules from IEC 61140 and IEC 60364. Decentralized Rural Electrification Systems are designed to supply electric power for sites…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…