Rechercher

This part of IEC 61000 for EMC immunity requirements applies to electrical and electronic equipment intended for use in industrial locations, as described below. Immunity requirements in the frequency range 0 Hz to 400 GHz are covered. No tests need to be performed at frequencies where no requirements are specified. This generic EMC immunity standard is applicable if no relevant dedicated…

B108-18, Part 1 Compressed natural gas refuelling stations installation code 1 Scope 1.1 Part 1 of this Code applies to all compressed natural gas refuelling stations, including those that are intended for fleet or public dispensing operations. 1.2 Part 1 of this Code does not apply to refuelling vehicles with liquefied natural gas (LNG). Refuelling vehicles with LNG is addressed in Part 2…

1 Scope 1.1 This security evaluation standard applies to the testing of network connected components of healthcare systems. It applies to, but is not limited to, the following key components: a) Medical devices; b) Accessories to medical devices; c) Medical device data systems; d) In vitro diagnostic devices; e) Health information technology; and f) Wellness devices.

IEC 61010-031:2015+A1:2018 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a…

IEC 61010-031:2015+A1:2018 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a…

This document gives general and dimensional specifications for flanged heads, flange clamps, ports and mounting surfaces applicable to four-screw, one-piece square flange clamp type tube connectors and hose fittings for use at a pressure of 42 MPa [420 bar[1]]. It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals. These connections are intended for…

IEC 60335-2-6:2014+A1:2018 deals with the safety of stationary electric cooking ranges, hobs, ovens and similar appliances for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral, and 480 V for other appliances. This International Standard also includes some requirements for ovens that are intended to be used on board…

IEC 60335-2-6:2014+A1:2018 deals with the safety of stationary electric cooking ranges, hobs, ovens and similar appliances for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral, and 480 V for other appliances. This International Standard also includes some requirements for ovens that are intended to be used on board…

IEC 62351-3:2014+A1:2018 specifies how to provide confidentiality, integrity protection, and message level authentication for SCADA and telecontrol protocols that make use of TCP/IP as a message transport layer when cyber-security is required. Although there are many possible solutions to secure TCP/IP, the particular scope of this part is to provide security between communicating entities at…

IEC 62680-1-3:2018 defines the USB Type-C™ receptacles, plug and cables.<br /> The USB Type-C Cable and Connector Specification defines a new receptacle, plug, cable and detection mechanisms that are compatible with existing USB interface electrical and functional specifications.  This specification covers the following aspects that are needed to produce and use this new USB cable/connector…