Methods of measurement for radio transmitters - Part 5: Measurements particular to transmitters and ...
Intended for type tests and acceptance and factory tests. The performance characteristics measured in accordance with this standard make it possible to compare the results of measurements made by different observers.
Standard Tolerances for Linear Dimensions - Inch and Metric
1. Scope
1.1 This Standard gives tables of standard tolerances for linear dimensions in both inch and metric units, covering a range of sizes up to 200 inches or 5,000 millimetres. Tolerances are provided in a series of grades which cover the full range of precision, from ultra precise products such as gauging elements to coarse tolerances suitable for rough work, and for many types of…
1. SCOPE
1.1 This Standard applies to cord-connected room air conditioners rated not
more than 250 volts, single phase, with a rated capacity not over 36,000
Btu/hr, designed to be used in accordance with the Rules of Canadian Electrical
Code, Part I.
1.2 This Standard applies to self-contained air-cooled window, or console or
built-in-wall type room air conditioners, which have…
Establishes uniform requirements for judging the electrical, mechanical and climatic properties of capacitors, describes test methods and gives recommendations for standard dimensions and classification into categories,
Radio-frequency cables - Part 0: Guide to the design of detailed specifications
Lays down requirements for flexible or semi-flexible radio-frequency cables of coaxial or twin conductor types designed for use in radiocommunication equipment and in electronic devices employing similar techniques. The dielectric may be of the solid, air-spaced, or semi-airspaced types, consisting of a thermoplastic of low-loss polymeric resin or of a thermosetting compound, or of a mineral…
Applies to new voltage transformers for use with electrical measuring instruments and electrical protective devices at frequencies from 15 Hz to 100 Hz.
The general requirements apply to all voltage transformers, but, for certain types, e.g. capacitor voltage transformers, the requirements are subject to the modifications stated in the appropriate chapter. Although the requirements relate…
Environmental testing. Part 2: Tests. Test Ec: Drop and topple, primarily for equipment-type specime...
Determines the effect on a specimen of simple standard treatments which are representative of the knocks and jolts likely to occur during repair work or rough handling on a table or bench.
Has the status of a basic safety publication in accordance with IEC Guide 104.
1. DEFINITION
1.1 This standard applies to two types of gasoline suitable for use in automotive and spark ignition engines operating under all climatic conditions.
Pipes, Ducts and Fittings for Residential Type Air Conditioning Systems
1. SCOPE
1.1 This Standard applies to pipes, ducts, and fittings manufactured for use
in residential type air conditioning systems, (winter, summer, or year round)
in the following classifications:
(a) Flue pipe, vent connectors, elbows, angles, and accessories;
(b) Plenum chambers, ducts, and accessories;
(c) Take-offs;
(d) Round duct, elbows, angles,…
1. Scope
1.1 This Standard applies to electrically operated clothes washing and dishwashing machines including such washing machines in combination with other devices (such as combination washing and drying machines) for potentials of 600 volts or less, intended to be used in accordance with the rules of the Canadian Electrical Code, Part I.
For convenience only, the short terms clothes…
