1. Scope
1.1 This Standard applies to complete commercial-industrial steam cleaning
machines which are either gas*-fired or oil+-fired.
*Natural, manufactured or liquefied petroleum gas, etc.
+Grades as listed in CSA Standard B140.0, Definitions and General Requirements
for Oil Burning Equipment.
1.2 The requirements of Clauses 1 to 8, apply to both oil-fired steam cleaning
machines…
Low-frequency cables and wires with p.v.c. insulation and p.v.c. sheath - Part 3: Equipment wires, T...
Applicable to equipment wires with solid or stranded conductor, polyvinyl chloride (PVC) insulated, in singles, pairs and triples. The object of this standard is to specify requirements for wires used for the internal wiring of telecommunication equipment and of industrial and consumer electronic equipment.
1. SCOPE
1.1 This Standard applies to oil burning assemblies comprising a vapourizing
burner and such devices as may be required to control the supply of fuel to the
burner.
1.2 This Standard applies only to oil burner assemblies intended for use with
either kerosene, No. 1 or No. 2 fuel oil as classified in CSA Standard B140.0.
1.3 This Standard applies to oil burner assemblies…
Nominal cross-sectional areas and composition of conductors of insulated cables
Specifies standardized nominal cross-section areas from 0.5 mm2 to 2 000 mm2, numbers and diameters of wires and resistance values of conductors in electric cables and flexible cords.
Classifies conductors for:
1) Cables for fixed installations
- Class 1, solid conductors;
- Class 2, stranded conductors.
2) Flexible copper conductors
- Class 5,
- Class 6 (more flexible than…
1. Scope
1.1 This Standard applies to cord-connected, motor-operated floor surfacing
and cleaning machines rated at 600 volts or less which are designed to be used
in accordance with the Rules of the Canadian Electrical Code, Part I, on an ac
or dc circuit.
1.2 This Standard applies to commercial and industrial floor polishing
machines, floor scrubbing machines, sanders, grinders or…
Method of measurement of current noise generated in fixed resistors
Standardizes a method of measurement and associated test conditions for use in the determination of the magnitude of current noise generated in fixed resistors so as to make possible the comparison of the results of measurements. Constitutes a description of the measurement system and procedures recommended for use in assessing the 'noisiness' or magnitude of current noise generated in…
Radio-frequency connectors - Part 1: General requirements and measuring methods
Serves as a generic specification providing the basis for the sectional standards which apply to individual connector types. Establishes uniform concepts and procedures concerning : - terminology; - standard ratings and characteristics; - testing and measuring procedures concerning electrical electrical and mechanical properties; - classification of connectors with regard to environmental testing…
General Purpose Electric Overhead Travelling Cranes
1. SCOPE
1.1 Scope. This Standard applies to all types of top-running electric overhead
travelling cranes for general use, with the exception of single girder cranes.
The Standard is not intended to apply to steel mill type cranes, which are
covered by other specifications, such as those of the Association of Iron and
Steel Engineers (AISE) and the British Iron and Steel Research…
1. Scope
1.1 This Standard covers asphalt roofing in shingle form, composed of roofing felt saturated and coated on both sides with asphalt, and surfaced on the weathered side with granulated slate or equivalent mineral material of solid or mixed colours.
1.2 This Standard covers the types of shingles listed in Clause 2.1 intended to be used with Appendix A.
