Lays down the general performance requirements and standardization principles. Is intended to cover types designed to use crimped, soldered and welded contacts accommodating aircraft cables. Does not define a particular type dimensionally. Outlines the basic design, mechanical and electrical requirements and basic environmental conditions of operation.
Oil of lime, Mexico (Citrus aurantiifolia (Christmann) Swingle) obtained by mechanical means
In the Standard two types of oil are distinguished. Typ A is obtained by centrifuging the emulsion of juice and oil obtained by crushing the whole fruits. Typ B is produced by centrifuging the emulsion of water and oil obtained by grating the fruits under water spraying. In a table the requirements for the characteristics of the two types of the oil are listed.
The projectors described here are the types most commonly used for educational and training purposes. Specialized projection equipment is not dealt with. This part of the standard covers the dimensions of projection stages and location pins to ensure compatibility between the projectors and transparencies.
Marine automatic radar plotting aids (ARPA) - Operational requirements - Methods of testing and test...
Specifies the performance and type testing of marine automatic radar plotting aids (ARPA) required by Regulation 12 of Chapter V of 'The International Convention for the Safety of Life at Sea' (SOLAS) 1974, as amended.
Establishes minimum performance standards and methods of testing and required test results for ARPA.
Standard for Halogenated Agent Hand and Wheeled Fire Extinguishers
1.1 These requirements cover the construction and operation of halogenated agent
hand portable and wheeled type fire extinguishers.
1.2 Halogenated agent type fire extinguishers shall also comply with the
requirements of the Standard for the Rating and Fire Testing of Fire Extinguishers, CAN4-S508.
NOTE: Reference to each applicable Test Method for a requirement is indicated by the
letters…
Covers requirements for Type B Gas Vents intended for the venting
of flue gases having temperatures not exceeding 245 degrees C,
and Type BW Gas Vents intended for the venting of flue gases from
gas-fired recessed heaters.
1. Scope
1.1 This Standard provides rules and requirements for the design, fabrication, erection, inspection, testing, maintenance, and use of scaffolding equipment, materials, and components where scaffolds are erected to provide working platforms for workers and materials during the construction, alteration, repair , or demolition of buildings and other structures.
1.2 This Standard…
This Guide establishes basic safety principles for technical bodies preparing national and international standards for products which are intended specifically for use by children; these principles should also apply to products with which children are likely to come into contact. The following aspects are considered: ergonomic considerations, toxicity, flammability and thermal injuries, ingestion…
This Guide establishes basic safety principles for technical bodies preparing national and international standards for products which are intended specifically for use by children; these principles should also apply to products with which children are likely to come into contact. The following aspects are considered: ergonomic considerations, toxicity, flammability and thermal injuries, ingestion…
Non-incendive Electrical Equipment for Use in Class 1, Division 2 Hazardous Locations
1. Scope
1.1
This Standard applies to process measurement and control equipment that has
been designed and assessed for use either in, or in conjunction with, Class I,
Division 2 hazardous locations as defined in the Canadian Electrical Code, Part
I. The principles may also be applied to other similar types of equipment.
1.2
This Standard also covers portable battery-powered equipment.
1.3…
