Rechercher

This National Standard of Canada is equivalent to International Standard CEI/IEC 1215:1993 (first edition, 1993-04) 1 Scope and object This International Standard lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 721-2-1. It applies only to crystalline…

This National Standard of Canada is based on International Standard IEC 60335-2-37:2000 (fourth edition 2000-02). 1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial deep fat fryers including pressurized types not intended for household use, their rated voltage being not more than 250 V for single-phase appliances…

This National Standard of Canada is based on International Standard IEC 60335-2-48:2000 (third edition, 2000-03). 1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial grillers and toasters not intended for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase…

1. Scope This Standard provides criteria for the structural design and appraisal of structures or structural elements made from wood or wood products, including graded lumber, glued-laminated timber, unsanded plywood, oriented strandboard (OSB), composite building components, shearwalls and diaphragms, timber piling, pole-type construction, prefabricated wood I-joists, structural composite…

1. Scope 1.1 This Standard describes testing procedures and states the performance requirements for general service incandescent reflector lamps. 1.2 This Standard includes performance requirements for(a) (a) wattage; (b) lamp efficacy; (c) centre-beam intensity; and (d) rated life. 1.3 This Standard applies to incandescent reflector lamps designed for general lighting use that…

It has the status of a horizontal standard in accordance with IEC Guide 108.

Gives the requirements for four types of non-heatshrinkable sleeving, extruded from silicone elastomer. These sleevings are normally available with internal diameter up to 25 mm and in a range of wall thicknesses between 0,1 mm and 2,0 mm. National standards may select a restricted list of preferred combinations of internal diameter and wall thickness.

Gives the requirements for four types of non-heatshrinkable sleeving, extruded from silicone elastomer. These sleevings are normally available with internal diameter up to 25 mm and in a range of wall thicknesses between 0,1 mm and 2,0 mm. National standards may select a restricted list of preferred combinations of internal diameter and wall thickness.

Specifies the particular safety requirements for ambulatory electrocardiographic systems. Within the scope of this standard are systems of the following types: a) systems that provide continuous recording and continuous analysis of the ECG allowing full re-analysis giving essentially similar results. The systems may first record and store the ECG and analyse it later on a separate unit, or…

Gives the requirements for three types of non-heatshrinkable sleeving, extruded from PVC. Sleeving of this type is normally available with an internal diameter up to 50 mm and in a range of wall thicknesses between 0,2 mm and 1,8 mm. Each sheet covers up to three levels of wall thickness, thin wall, standard wall and thick wall related to nominal internal diameter and with corresponding…