Rechercher

1. Scope 1.1 This Standard covers construction, general requirements, test methods, marking, and instructions that are common to some or all of the CSA B140 series of Standards. 1.2 This is not a complete Standard in itself and must be used in conjunction with one of the other Standards in the CSA B140 series to form a complete Standard for a particular type of oil-burning appliance or…

Z241.0-03 Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety requirements that apply to the other Standards in this Series. Z241.1-03 Vehicular Requirements for Park Model Trailers 1. Scope 1.1 Requirement Specification…

This National Standard of Canada is equivalent to International Standard CEI/IEC 60079-7:2001 (third edition, 2001-11). 1 Scope This part of IEC 60079 specifies the requirements for the design, construction, testing and marking of electrical apparatus with type of protection increased safety "e" intended for use in explosive gas atmospheres. This standard applies to electrical…

ISO 12243:2003 specifies a method for the determination of the amount of water-extractable protein in natural rubber (NR) gloves for medical use. The method is potentially suitable for the determination of extractable protein in other articles made from NR latex; however the extraction procedures and times have not been validated and will vary with the type of article to be tested. Other methods…

ISO 8871-2:2003 specifies evaluation procedures applicable to elastomeric parts used for drug containers and medical devices in order to guarantee the product identity between the samples evaluated in the (suitability test) acceptance process and the current supplies. The physical and chemical test procedures specified in this part of ISO 8871 permit the determination of the typical…

ISO 4628-1:2003 defines a system for designating the quantity and size of defects and the intensity of changes in the appearance of coatings and outlines the general principles of the system used throughout ISO 4628. This system is intended to be used, in particular, for defects caused by ageing and weathering, and for uniform changes such as colour changes, for example yellowing. The other parts…

This National Standard of Canada is equivalent to International Standard IEC 60601-2-47:2001 (first edition, 2001-07). 1.1 Scope Addition: This Particular Standard specifies the particular safety requirements for AMBULATORY ELECTROCARDIOGRAPHIC SYSTEMS, as defined in 2.101. Within the scope of this standard are systems of the following types: a) systems that provide continuous recording and…

1. SCOPE 1.1 This standard applies to a sealer used to prevent the release of asbestos fibres from asbestos-containing materials. This sealer is not suitable for highly friable materials.(1) 1.2 This standard helps the user to select a specific type and class of sealer, described in par. 3.1. It does not address concerns about any change in properties or characteristics of the material,…

1. SCOPE 1.1 This standard applies to an interior latex low gloss paint for use on walls and ceilings, either new or previously painted. 1.2 The paint is suitable for most types of wall surfaces, including wallboard, gypsum board, dry plaster, cement, brick and concrete block. For bathrooms and kitchens, coatings complying with CAN/CGSB-1.195 or CAN/CGSB-1.202, Type 2 may be preferable…

1 Scope 1.1 This Standard applies to (a) steam sterilizers that (i) have a chamber volume of 42.5 L (1.5 ft3) or greater; and (ii) are intended for use in health care facilities; (b) emergency (flash) sterilizers; and (c) washer-disinfectors (when used in sterilizer mode). Notes: (1) In this Standard, <sterilizer> is used as a blanket term for the three types of…