Rechercher

1.1 Facilities 1.1.1 Types of facilities 1.1.1.1 This Standard addresses the establishment and implementation of ALs for Class I nuclear facilities and uranium mines and mills. Notes: 1) In this Standard, any type of Class I nuclear facility or uranium mine and mill is included in the term “nuclear facilities”. 2) Conventional waste management facilities (e.g., landfills, incinerators,…

1.1 This Standard applies to surge protective devices (SPDs) intended for: a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up to 750 V ac; c) installation between the secondary of the service transformer and the line side of the service equipment overcurrent protective device. These devices…

1.1 This Standard applies to surge protective devices (SPDs) intended for a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up to 750 V ac; c) installation on the load side of the main overcurrent protective device; and d) indoor or outdoor use in accordance with the Canadian Electrical Code, Part I…

1.1 This International Standard covers those aspects to be considered when electrical/electronic/programmable electronic (E/E/PE) systems are used to carry out safety functions. A major objective of this standard is to facilitate the development of product and application sector international standards by the technical committees responsible for the product or application sector. This will allow…

1.1 This standard applies to pin and sleeve type plugs, receptacles, power inlets, and connectors, rated up to 800 amperes and up to 600 volts ac or dc, and which may include up to eight pilot contacts. These devices are intended to provide power from branch circuits, or are for direct connection to the branch circuit in accordance with the Canadian Electrical Code Part I, the National…

ISO 6405-1:2017 standardizes symbols for use on operator controls and other displays applicable to multiple types of earth-moving machinery as defined in ISO 6165. NOTE 1 ISO 6405‑2 covers symbols for specific types of earth-moving machines, equipment, and accessories. NOTE 2 ISO 7000 and IEC 60417 can be consulted for additional internationally standardized symbols of potential…

ISO 6405-2:2017 standardizes symbols for use on operator controls and other displays on specific types of earth-moving machinery as defined in ISO 6165. NOTE 1 ISO 6405‑1 covers common symbols that apply to multiple types of earth-moving machinery. NOTE 2 ISO 7000 and IEC 60417 can be consulted for additional internationally standardized symbols of potential relevance to earth-moving…

IEC 63044-3:2017 provides the electrical safety requirements related to the HBES/BACS network in addition to the product safety standards for HBES/BACS devices. It also applies to devices used within an HBES/BACS network for which no specific HBES/BACS product safety standard exists. In addition, it defines safety requirements for the interface of equipment intended to be connected to an HBES/…

ISO 18400-101:2017 specifies the procedural elements to be taken in the preparation and application of a sampling plan. The sampling plan describes among other things what laboratory samples are to be taken, how they are to be taken and from where they are to be taken, in order that the objectives of the investigation programme can be achieved. The principles or basic rules outlined in this…

IEC 60317-67: 2017 specifies the requirements of enamelled rectangular aluminium winding wire of class 105 with a sole coating based on polyvinyl acetal resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The range of nominal conductor dimensions covered by this standard is: <table align="center"…