Rechercher

Applies to terminology for tools and equipment used in live working. This standard is not intended to be a dictionary giving detailed definitions of all the terms used in live working, but only the necessary details, without indications of their components and their methods of use, to permit identification of the tools and equipment and to standardize their names.

1.1 Scope This Standard applies to elevating rolling work platforms used on a level surface and that are incapable of being self-propelled from an operating station on the work platform, and that are used to position personnel, along with their tools and necessary materials, at overhead work locations. 1.2 Purpose The purpose of this Standard is to outline the requirements and…

1. Scope 1.1 This Standard describes a procedure for the measurement of A-weighted sound levels in and around industrial, institutional, or commercial sites. 1.2 This Standard applies to the measurement of sounds that are essentially non-impulsive in nature. 1.3 This Standard may be used to determine: (a) Those operating areas where permitted sound levels are exceeded; (…

The purpose of this national painting standard is to assist all parties concerned, to prepare job specifications and contracts for the painting of residential, commercial and institutional properties to ensure proper execution of the work and satisfactory appearance and durability of the applied paints.

Specifies requirements for spectacle filters and protectors within the spectral region 0,2 to 1000 micron. The work, which was staggered over several years, represents a basic study for which a majority consensus was reached at the international level. To take account of new developments and knowledge relating to lasers a revision of this standard will be undertaken.

1. Scope 1.1 This Standard covers procedures for the measurement of airborne sound originating from industrial equipment in the working environment rather than in a standardized environment. 1.2 This Standard describes the following three procedures: (a) A procedure for determining the A-weighted sound levels at representative points around the equipment (see Clause 5); (b) A…

1. Scope 1.1 General 1.1.1 This Standard outlines the safety precautions to be observed and procedures to be used before, during, and after demolition operations to provide for the safety of the public, workers, and property. 1.1.2 Demolition procedures for both systematic and rapid progressive failure methods are described. Particular emphasis is given to areas of known concern…

1. Scope 1.1 This Standard applies to add-on heat pumps for comfort heating or heating and cooling not exceeding 20 kW in the cooling mode and rated at 600 V or less, single or polyphase, intended to utilize the fan assemblies and duct work of the existing installed furnaces to form the complete functional systems where the existing parts are not covered by this Standard. Note: For…

1. Scope 1.1 General 1.1.1 This Standard establishes minimum requirements for the design, construction, installation, operation, inspection, testing, alteration, and maintenance of permanently installed manlifts for the vertical transportation of authorized personnel and, where applicable, their tools and equipment. 1.1.2 This Standard does not apply to: (a) mine hoists; (b) hoists for…

1. SCOPE 1.1 This standard applies to inorganic zinc coating for use on steel superstructures, decks and hulls of vessels, bridges, towers, off-shore drilling rigs, tank linings and reconditioned equipment. 1.2 For detailed information on the intended uses of this coating see par. 8.2.