Power sources for manual metal arc welding with covered electrodes and for the TIG process
Specifies the information to appear on the rating plate and describes test methods to verify the compliance of the power source with this International Standard. Applies to the types of power sources most commonly used in industrial applications for manual metal arc welding with covered electrodes and for the TIG process, except for oil-cooled power sources.
Building construction — Tolerances for building — Part 5: Series of values to be used for specificat...
Specifies a series of values from which tolerances shall be chosen for dimensional specification of building components and constructions. The basis for the determination of the tolerances to be specified is dealt with in other standards, especially ISO 3443 parts 1 to 4 and ISO 4464.
Starches and derived products — Determination of chloride content — Potentiometric method
A solution or suspension of the sample is titrated with a standard volumetric silver nitrate solution. The method is not applied to cationic starches and amyloids soluble when cold.
Gives general instructions and specifies methods od analysis. The methods to be used are determination of density at 20 °C, determination ofdry residue after evaporation on a water bath, measurement of colour, determination of distillation yield, determination of water content, detection of the alkalinity or acidity to phenolphthalein, spectrometric detection of content of carbonyl compounds in…
General rules for a model third-party certification system for products
The rules are valid for the following type of certification system: a third party certification system of determining conformity with product standards through initial testing and assessment of a factory quality management system and its acceptance followed by surveillance (corresponds to system No. 5 as described in ISO/ITC publication "Certification - Principles and practice"). A…
General rules for a model third-party certification system for products
The rules are valid for the following type of certification system: a third party certification system of determining conformity with product standards through initial testing and assessment of a factory quality management system and its acceptance followed by surveillance (corresponds to system No. 5 as described in ISO/ITC publication "Certification - Principles and practice"). A…
Sealing Compound, One Component, Elastomeric, Chemical Curing
Applies to one-component joint sealing compounds that cure to a
rubber-like solid and are suitable for sealing, caulking or
glazing applications. A sealing compound meeting the requirements
of this standard is designated by the manufacturer to be one or
more of the types, classes, grades, and uses defined in Section 3
of this standard. For application on a particular substrate the
primer,…
1. Scope
1.1 This Standard covers decorative and industrial plywood made primarily with hardwood veneer faces. It also includes decorative plywood made with certain softwood veneer faces.
1.2 This Standard provides minimum requirements in terms of construction, sizes, grades, sanding, and glue bond.
1.3 This Standard also applies to hardwood plywood wall panelling in all…
