Men's Polyester/Cotton Pants, Hospitals and Institutions
This standard applies to pants made from 65% polyester/35% cotton fabric
for use by personnel of hospitals and institutions in areas where synthetic
fabric garments are permitted, and where static electricity is not a hazard.
This standard applies to water based presensitized aluminum printing plates,
anodized and non-anodized, for use on sheet-fed and web-fed lithographic
presses.
This standard applies to wash solvents intended for use in the removal of
printing ink films from the rollers and blankets of offset lithographic
printing presses.
Standard for Space Heaters for use with Solid Fuels
1. SCOPe
1.1 This Standard applies to hand-fuelled solid-fuel fired space heaters of the
radiant, convection or forced-circulating type, intended for residential
heating.
1.2 This Standard applies to:
A Space heaters having provision for venting directly to the outdoors;
B Outdoor-aired space heaters intended for installation primarily in
mobile…
1.1
This standard states the requirements for a sulphamic acid type of
compound used to remove lime deposits from institutional kitchen equipment.
1.2
For more detailed information on intended uses, see par. 7.2.
1.1
This standard applies to three grades of kerosine type aviation turbine fuel
consisting entirely of hydrocarbon compounds, except as otherwise specified.
1.2
Grades JET A and JET A-1 describe fuels normally used in commercial operations.
Grade F-34 describes a fuel used within the NATO armed forces.
1.3
Jet A is suitable for summer use (May 1 - October 31) without operational…
1.1
This standard applies to two grades of wide cut type aviation turbine fuel
consisting entirely of hydrocarbon compounds except as otherwise specified.
1.2
Grade JET B describes a fuel normally used in commercial operations. Grade F-40
describes a fuel used within the NATO armed forces.
1.1
This Standard applies to connectors for use with copper or aluminum conductors,
or both, for providing contacts between current-carrying parts such as
terminals, between lengths of wire and tap connectors, in accordance with the
Canadian Electrical Code, Part I, as follows:
(a) pressure wire connectors intended to hold one or more copper or
aluminum conductor(s);
(b) connectors…
