Rechercher

Defines a standard test method to assess the extent and the effect of a controlled salt-laden atmosphere on the finish of a specimen (essentially a connector).

Defines a standard test method to assess the ability of components (essentially connectors) to withstand specified severities of acceleration.

Defines a standard test method to assess the ability of components (essentially connectors) to withstand specified severities of bump.

Defines a standard test method to assess the ability of components (essentially connectors) to be stored and/or to function under conditions of high relative humidity and to observe the effects of such high humidity when combined with important temperature changes.

Defines a standard test method to verify that gas-tight areas have been formed between wrapped wire and the post of a wrapped connection.

One of a series of IEC standards for incandescent lamps to be used in headlamps, fog-lamps and signalling lamps of road vehicles.

Gives a method for calculating the cyclic rating factor, for cables of all voltages, where partial drying out of the surrounding soil is anticipated. The method is based on one of the three methods published in a CIGRE document. The method is applicable to any type of cable, but it is recommended that it should be applied only to installations of one multi-core cable or to three single-core…

Deals with the safety of flexible sheet heating elements. These are incorporated into a building to heat rooms. The rated voltage is less than 250 V for single-phase installations and 480 V for other installations. For heated blankets and pads, see IEC 60335-2-17. For heated mats and foot warmers, see IEC 60335-2-81. This standard does not cover under-carpet heaters, nor flexible heating elements…

IEC 61386-21:2002 specifies the requirements for rigid conduit systems. This part 21, which specifies particular requirements for rigid conduit systems, is to be used in conjunction with IEC 61386-1, Conduit systems for electrical installations – Part 1: General requirements, and its amendments. It was established on the basis of the first edition (1996) of that standard and its amendment 1 (2000…

IEC 61386-23:2002 specifies the requirements for flexible conduit systems. This part 23, which specifies particular requirements for flexible conduit systems, is to be used in conjunction with IEC 61386-1, Conduit systems for cable installations – Part 1: General Requirements 1, and its amendments. It was established on the basis of the first edition (1996) of that standard and its amendment 1 (…