Rechercher

ISO 16329:2003 specifies the structure, performance, inspection and testing of heading control systems to be installed on board crafts operating under the following conditions: speed exceeding 30 kn and up to 70 kn;maximum rate of turn 20°/s;the normal range of operation between 70°N and 70°S should, as required by chapter 13 of the HSC Code, comply with the minimum performance requirements…

ISO 16014-4:2003 specifies a method for determining the average molecular mass and the molecular mass distribution of polymers by size-exclusion chromatography (SEC) using an organic eluent at temperatures between 60 °C and 180 °C. The average molecular mass and the molecular mass distribution are calculated from a calibration curve constructed using polymer standards. Therefore this method is…

ISO 10012:2003 specifies generic requirements and provides guidance for the management of measurement processes and metrological confirmation of measuring equipment used to support and demonstrate compliance with metrological requirements. It specifies quality management requirements of a measurement management system that can be used by an organization performing measurements as part of the…

ISO 14694:2003 gives specifications for vibration and balance limits of fans for all applications except those designed solely for air circulation, for example, ceiling fans and table fans. However, it is limited to fans of all types installed with a power of less than 300 kW or to commercially available standard electric motor with a maximum power of 355 kW (following an R20 series). For fans of…

1 PURPOSE This standard specifies the requirements that products and materials in contact with drinking water shall conform to in order to preserve drinking water quality. This standard considers the incidence of products and materials in contact with drinking water on public health and the aesthetic quality of the water. This standard specifies the methods for evaluation of products and…

The intention of this standard is to establish uniform requirements for the radio disturbance level of the equipment contained in the scope, to fix limits of disturbance, to describe methods of measurement and to standardize operating conditions andinterpretation of results.

Specifies the measurement method of total AC losses by the pickup coil method in Cu/Nb-Ti composite superconducting wires exposed to a transverse alternating magnetic field. The losses may contain both hysteresis and coupling losses. The standard method to measure only the hysteresis loss in DC or low-sweep-rate magnetic field is specified in IEC 61788-13.

This part of IEC 61000 sets high-altitude electromagnetic pulse (HEMP) immunity requirements for electrical and electronic equipment intended for use indoors. The indoor HEMP environment depends on the electromagnetic shielding quality of a facility and the level of protection against the conducted environment. This standard is intended for all facility types including residential, commercial,…

ISO 12648:2002 applies to printing press systems, including auxiliary equipment and finishing machines, in which all the machine actuators (e.g. drives) of the equipment in the system are controlled by the same control system. It is applicable only to systems in which a printing press is part of the system. In cases where a binding/finishing system is not integrated with a printing press, ISO…