Rechercher

Applies if all of the following conditions are satisfied: a) inspected are continuing series of lots of discrete items supplied by one producer from one production process; b) only a single quality characteristic x is taken into consideration; c) production is stable and x has a known standard deviation; d) an upper or lower limit (or both) is defined.

1. Scope 1.1 This Standard applies to ground fault circuit interrupters (GFCIs) intended for installation in non-hazardous locations at nominal system voltages of 600 V and less, in accordance with CSA Standard C22.1, Canadian Electrical Code, Part I, in order to automatically deenergize some part of an electrical installation. 1.2 This Standard includes provisions for Class A GFCIs, the…

1.1 This Standard applies to fixed and operable windows, covered by CSA Standard CAN/CSA-A440, and to sliding glass doors, covered by CGSB Standard CAN/CGSB-82.1, that are factory-assembled and intended for vertical installation in buildings. Note: The term "window" is often used within this Standard to include both windows and sliding glass doors. 1.2 This Standard specifies…

Note: Clause numbers in this part of the User Guide correspond to those in the body of CSA Standard A440.2. Commentary is not provided for all Clauses in the Standard. 1.1 The angle from horizontal at which windows are installed has some effect on thermal properties. The Standard specifies the determination of reference values for vertical installation, as most windows are installed at…

1.1 This Standard specifies the requirements for distribution transformers intended primarily for operation by electric utilities. Note: The operation of transformers complying with this Standard, by other than an electric utility, may be subject to additional requirements by the electrical inspection authority having jurisdiction under Part I of the Canadian Electrical Code. 1.2 This…

Applies to hermetic refrigerant motor-compressors rated 600 V or less, for use in air-conditioning and refrigerating equipment that comply with the Standards applicable to such equipment.

Describes material and hardness, cutting geometry, run-out tolerances, and the marking. Applies to standard taps in accordance with ISO 529, ISO 2283, ISO 2284, and ISO 2857.

Specifies tests which apply to: metals and their alloys; certain metallic coatings; certain conversion coatings; certain anodic oxide coatings; organic coatings on metallic materials. Annex A forms an integral part of this Standard. Annex B is for information only.

Applies to raw rubber and rubber products having zinc contents at a minimum of 0,05 %. This second edition cancels and replaces the first edition (1981). Annex A forms an integral part of this standard.

Does not apply to roasted, salted or any other type of processed pine nuts, or to pine nuts obtained by burning of the cones. Annexes A, B and C form an integral part of this standard.