Rechercher

ISO 17387:2008 specifies system requirements and test methods for Lane Change Decision Aid Systems (LCDAS). LCDAS are fundamentally intended to warn the driver of the subject vehicle against potential collisions with vehicles to the side and/or to the rear of the subject vehicle, and moving in the same direction as the subject vehicle during lane change manoeuvres. This standardization addresses…

Cancels and replaces the second edition (1979). Specifies the maximum chamfer dimensions of metric series rolling bearings, for which boundary dimensions, including chamfer minimum dimensions, are given in other International Standards. Gives also requirements for the maximum dimensions of the corresponding shaft and housing filet radii. Does not apply to chamfers, for which dimensions are not…

This document defines a Universal Cybersecurity Labelling Framework for the development and implementation of cybersecurity labelling programmes for consumer IoT products and includes guidance on the following topics: • Risks and threats associated with consumer IoT products; • Stakeholders, roles and responsibilities; • Relevant standards and guidance documents; • Conformity assessment options…

This International Standard defines the procedures for noise control of mainly open plants. It is applicable to the following: _ specification of procedures for noise control during engineering of a new plant and modification/extension of existing plants (construction noise procedures are outside the scope of this International Standard but should be considered); _ definition of responsibilities…

This document: •       provides guidelines for the implementation of systems for the management of identity information, and •       specifies requirements for the implementation and operation of a framework for identity management. This document is applicable to any information system where information relating to identity is processed or stored." to “This document: ·       provides…

This standard establishes the calculation procedures for determining specification limits for external andinternal cylindrical involute gearing with constant gear ratio when the desired tooth thickness is known.This standard also shows the relationships between backlash and the tooth thickness, centre distance,and tooth deviations in a pinion and gear mesh.

Standard W3C XML Schema for exchanging content between ISO/IEC11179-3:2013 metadata registries

The focus of ISO 16757 is the support of manufacturers to provide their product data in electronic product catalogues. This part of the standard – ISO 16757 Part 5: Product catalogue exchange format - describes how product catalogue data is exchanged as IFC format according to ISO 16739-1 from manufacturers to designers of building services systems. With ISO 16739-1 (IFC), an open language…

ISO 2719:2016 describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C. CAUTION - For certain mixtures no flash point, as defined, is observed;…

This document provides guidance to standards developers on how to take account of climate change in the planning, drafting, revision and updating of ISO standards and other deliverables. It outlines a framework and general principles that standards developers can use to develop their own approach to addressing climate change on a subject-specific basis. It aims to enable standards developers to…