Rechercher

This International Standard proposal specifies technical requirements and evaluation method for temperature correction on temperature measurement in radiosonde due to solar radiation in sounding experiment. This International Standard is applicable to the correction of temperature measurement traceable to SI unit in radiosonde boom sensors according to variations of pressure and air speed under…

The purpose of this International Standard is to provide a test method for the calibration of radiosonde humidity sensors with varying temperature and relative humidity using laboratory setups. The main scope of this International Standard is as follows: a) Technical requirements for laboratory setups needed for the calibration of radiosonde humidity sensors. b) Test procedure for calibrating…

Basis for this method is the laboratory sample obtained by the method specified in ISO 948. The principle of determination consists in grinding the laboratory sample, which has been previously mixed, to obtain particles of the size specified in the International Standard appropriate to the spice or condiment concerned or, if not so specified, to obtain particles of size approximately 1 mm.

ISO 11227:2012 describes an experimental procedure for assessing the behaviour, under orbital debris or meteoroid impacts, of materials that are intended to be used on the external surfaces of spacecraft and launch vehicle orbital stages. ISO 11227:2012 provides a unified method by which to rank materials. The ejecta production characteristics of different materials are compared under…

This document augments the capabilities of the mobile driving licence (mDL) standardized in ISO/IEC 18013-5 with the following additional functionality: —     presentation of a mobile driving licence to a reader over the internet.

This document defines basic terms, symbols, and units of measurement for the field of laser technology in order to unify the terminology and to arrive at clear definitions and reproducible tests of beam parameters and laser-oriented product properties. NOTE The laser hierarchical vocabulary laid down in this document differs from that given in IEC 60825?1. ISO and IEC have discussed this…

ISO 17724:2003 defines terms relating to graphical symbols, principally symbols for public information and use on equipment and safety signs. It does not include terms related to graphical symbols for diagrams [technical product documentation (tpd) symbols]. The definitions are intended to serve as a basis for consideration by those concerned with producing new, or revising existing standards.

This document provides a self-assessment of an organization’s human-centred design principles, processes, and activities throughout the life cycle of computer-based interactive systems, It also provides an overview of information given in the ISO 9241-200 series. It is intended to be used as an introduction and self-assessment guide to human-centred design (HCD). Its target audience are personnel…

ISO 14025:2006 establishes the principles and specifies the procedures for developing Type III environmental declaration programmes and Type III environmental declarations. It specifically establishes the use of the ISO 14040 series of standards in the development of Type III environmental declaration programmes and Type III environmental declarations. ISO 14025:2006 establishes principles for…