Audiovisual, video and television equipment and systems. Part 20: Methods of measuring and reporting...
Applies to 16 mm motion picture film projectors for 16 mm films for general application. Defines characteristics affecting the performance of 16 mm projectors related to picture quality and to the quality of sound recorded on and reproduced from photographic and magnetic sound tracks. Specifies methods of measurement of those characteristics, and the conditions under which such measurements shall…
Alarm systems. Part 1: General requirements. Section Three: Environmental testing
Specifies environmental test methods to be used for testing components of an alarm system. Provides a standard range of tests to determine the suitability of components and equipment for use, storage and transportation under various environmental conditions.
Specficiation for combined flexible materials for electrical
insulation. Part 3: Specifications for ...
This standard specifies dimensional and performance requirements
for individual combined flexible materials. lt is in the form of
groups of sheets. This standard contains sheets: 100, 101, 102, 110,
111, 112, 113, 114, 115, 302, 303, 312, 313, 315, 320, 330, 502,
503, 505.
Tests for power cables with extruded insulation for rated voltages above 30 kV (Um = 36 kV) up to 15...
Specifies test requirements for power cables for fixed
installations with extruded insulation of the types listed in
Sub-clause 1.4 for rated voltages, U, above 30 kV (Um = 36 kV) up
to and including 150 kV (Um = 170 kV).
The requirements apply to cables for usual conditions of
installation and operation, but not to special cables, such as
submarine cables, for which modifications to the standard…
Standard for Hose for Flammable and Combustible Liquids
Covers requirements for hose, up to 31.8 mm diameter, used
primarily for conducting flammable and combustible liquids
(handled at temperatures ranging from -54 degrees C to +50
degrees C) into the fuel storage tanks of end-use vehicles. This
does not include aircraft refuelling service.
Standard Method of Test for Surface Burning Characteristics of Building Materials and Assemblies
Applicable to any type of building material that, by its own
structural qualities or the manner in which it is applied, is
capable of supporting itself in position or may be supported in
the test furnace to a thickness comparable to its recommended
use.
Standard Method of Test for Surface Burning Characteristics of Flooring,
Floor Covering, and Misce...
1. SCOPE
1.1 This method is applicable to the finished surface or covering of a floor
extending to a maximum depth of 65 mm. It may also be applied to materials
that cannot conveniently be tested in a ceiling mounted configuration.
Thermoplastic and loose fill materials might be included in this category.
1.2 The primary purpose of the test is to determine the comparative burning…
Programming language processors - Test methods - Guidelines for their development and acceptability
This Technical Report type 3 describes a methodology for determining whether a programming language processor possesses the required characteristics stated in the International Standard for the particular programming language for which it is intended.
