Rechercher

1. Scope 1.1 This Standard sets forth methods for both new installation and replacement installation of factory-assembled windows and exterior doors that are intended for vertical installation in small buildings primarily used for residential occupancy. 1.2 This Standard provides minimum requirements that will help to ensure the installation of windows in an effective manner, such…

CAN/CSA-A5-98 Portland Cement 1. Scope 1.1 Scope This Standard addresses the definition of Portland cement; the chemical, physical, and uniformity requirements; the tests required; the procedures for inspection and sampling; the units of measurement, packaging, marking, and storage. 1.2 Types The five types of Portland cement covered in this Standard are identified as follows: Type…

1. Scope 1.1 Scope This Standard addresses the definition of Portland cement; the chemical, physical, and uniformity requirements; the tests required; the procedures for inspection and sampling; the units of measurement, packaging, marking, and storage. 1.2 Types The five types of Portland cement covered in this Standard are identified as follows…

1. Scope 1.1 This Standard addresses the requirements for two types of masonry cement for use in masonry mortar; Types N and S.

1. Scope 1.1 This Standard addresses the requirements for supplementary cementing materials consisting of natural pozzolans, fly ash, ground granulated slag, and silica fume, added at the mixing plant to supplement the Portland cement in concrete. 1.2 This Standard provides for the acceptance of a supplementary cementing material either on the basis of tests on samples of a single lot…

1. Scope 1.1 General This Standard addresses the definition of blended hydraulic cement; its chemical and physical requirements; the tests required; the procedures for inspection and sampling; the units of measurement; and its packaging, marking, and storage. The intent of this Standard is to define the properties of the blended product; it does not include cases in which the…

1. Scope 1.1 This Standard addresses the physical and chemical requirements for cementitious hydraulic slag.

1. Scope 1.1 General Test methods in this Standard address the chemical analysis of hydraulic cement and supplementary cementing materials. At the discretion of the laboratory, alternative methods demonstrated to be of acceptable precision and bias that further satisfy the qualification criteria of Clause 3 may be used for analysis. 1.2 Test Frequencies Refer to Table 1 of CSA…

1. Scope 1.1 This Standard sets out the various physical test methods for hydraulic cements, supplementary cementing materials, and cementitious hydraulic slag. It is divided into test methods and standard practices numbered A1 to A6, B1 to B7, and C1 to C8, representing dry tests, paste tests, and mortar tests, respectively. Each test method or standard practice contains a scope,…

1. Scope 1.1 This Standard describes the materials and equipment used in testing hydraulic cements, supplementary cementing materials, and cementitious hydraulic slag.