Rechercher

ISO 19901-4:2003 contains requirements and recommendations for those aspects of geoscience and foundation engineering that are applicable to a broad range of offshore structures, rather than to a particular structure type. Such aspects are site characterization, soil and rock characterization, and design and installation of foundations supported by the seabed (shallow foundations) and the…

ISO 8503-5:2003 describes a field method for measuring the surface profile produced by any of the abrasive blast-cleaning procedures given in ISO 8504-2. The method uses replica tape and a suitable gauge for measuring, on site, the roughness of a surface before the application of paint or another protective coating. The method is applicable within the range of profiles cited for a given grade (or…

1. Scope 1.1 ? The scope statement indicates which aspects and parts of pipeline systems and which service fluids are covered by the Standard. ? Carbon dioxide was added as a new service fluid in 1996. The definition of gas was changed in 1983 to accommodate the coverage of gaseous service fluids other than fuel gas and sour gas; however, until 1996, none had been added. ? The carbon…

1 Scope 1.1 This Standard provides requirements and recommended practices for the warehousing, storage, handling, and transportation of clean and sterile medical devices in facilities where open-inventory (?split-case?) storage and handling services are provided. Note: The storage facilities covered by this Standard include, but are not limited to, a) warehouses; b) storerooms; and c…

ISO 10381-4:2003 describes the sampling of soils of natural and near-natural sites;areas used for agriculture (arable and pasture sites);areas used for horticulture (including domestic gardens, allotments);areas used for special crop-cultivation, arboreal, vineyard, etc.;forest areas and woods. It is applicable to soil investigations and evaluations in the field;chemical, geochemical, physical,…

This National Standard of Canada is equivalent to International Standard ISO/TS 16949:2002 (second edition, 2002-03-01). 1 Scope 1.1 General ISO 9001:2000, Quality management systems - Requirements 1 Scope 1.1 General This International Standard specifies requirements for a quality management system where an organization a) needs to demonstrate its ability to consistently provide product…

ISO 14620-1:2002 defines the safety programme and the technical safety requirements that are implemented in order to comply with the safety policy as defined in ISO 14300-2. It is intended to protect flight and ground personnel, the launch vehicle, associated payloads, ground support equipment, the general public, public and private property, and the environment from hazards associated with space…

ISO 10381-2:2002 gives guidance on techniques for taking and storing soil samples so that these can subsequently be examined for the purpose of providing information on soil quality. ISO 10381-2:2002 gives information on typical equipment that is applicable in particular sampling situations to enable correct sampling procedures to be carried out and representative samples to be collected.…

Provides, in a convenient form, common rules for the design and the erection of electrical power installations in systems with nominal voltages above 1 kV a.c. and nominal frequency up to and including 60 Hz, so as to provide safety and proper functioning for the use intended. This standard applies to all high voltage installations except as stated otherwise in some cases specified in other parts…

ISO 10414-2:2002 provides standard procedures for determining the following characteristics of oil-based drilling fluids: drilling fluid density (mud weight);viscosity and gel strength;filtration;oil, water and solids contents;alkalinity, chloride content and calcium content;electrical stability;lime and calcium contents, calcium chloride and sodium chloride contents;low-gravity solids and…