Rechercher

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies requirements for the following aspects of building installation: a) site preparation; b) permanent foundations; c) anchorage to resist overturning and pier toppling due to wind…

ISO 10993-6:2016 specifies test methods for the assessment of the local effects after implantation of biomaterials intended for use in medical devices. ISO 10993-6:2016 applies to materials that are - solid and non-absorbable, - non-solid, such as porous materials, liquids, gels, pastes, and particulates, and - degradable and/or absorbable, which may be solid or non-solid. The test…

ISO 13143-2:2016 specifies the abstract test suite (ATS) to evaluate the conformity of on-board equipment (OBE) and roadside equipment (RSE) to ISO 12813 in accordance with the test suite structure and test purposes defined in ISO 13143‑1:2016. It provides a basis for conformance tests for dedicated short-range communication (DSRC) equipment (OBE and RSE) to enable interoperability between…

This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of their publications for products similar to those mentioned in the scope of this standard, in accordance with the principles laid down in IEC Guide 104 and lSO/lEC Guide 51. IEC 61010-2-120:2016…

IEC 62840-2:2016 provides the safety requirements for a battery swap system, for the purposes of swapping swappable battery system (SBS) of electric vehicles. The battery swap system is intended to be connected to the supply network. The power supply is up to 1 000 V AC or up to 1 500 V d.c, in accordance with IEC 60038. This standard also applies to battery swap systems supplied from on-site…

This part of ISO 19905 specifies requirements and guidance for the site-specific assessment of independent leg jack-up units for use in the petroleum and natural gas industries. It addresses: a) manned non-evacuated, manned evacuated and unmanned jack-ups; b) the installed phase at a specific site. To ensure acceptable reliability, the provisions of this part of ISO 19905 form an integrated…

IEC TS 62600-2:2016(E) provides the essential design requirements to ensure the engineering integrity of wave, tidal and other water current energy converters, referred to as marine energy converters (MECs), for a specified design life. Provides an appropriate level of protection against damage from all hazards that may lead to failure of the primary structure, defined as the collective system…

IEC TS 62600-102:2016(E) describes the required methods and the required conditions to determine the power performance of the Wave Energy Converter 2 (WEC 2) in Location 2, possibly at a different scale and with configuration changes to accommodate the new site conditions, in all cases based on measured power performance of WEC 1 in Location 1. This technical specification allows for assessment…

1.1 This Standard provides guidance and requirements for the design, fabrication, and testing of scaffolding equipment, materials, and components where scaffolds are erected to provide working platforms for workers and materials during the construction, alteration, repair, or demolition of buildings and other structures. This Standard also includes limited guidance on scaffolding assemblies…

1.1 This Standard provides requirements for the design and qualification of components for the monitoring and display of nuclear power plants (NPP) and irradiated fuel bay safety functions in the event of a design basis accident (DBA) or a design extension condition (DEC). Note: The requirements for a DBA and those for a DEC might differ. Where requirements differ for a DBA and a DEC, the…