Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use - Part 1: ...
This National Standard of Canada is based on International Standard IEC 61010-1:2001, and is common with UL 61010-1.
1 Scope and object
1.1 Scope
1.1.1 Equipment included in scope
This part of IEC 61010 specifies general safety requirements for electrical equipment intended for professional, industrial process, and educational use, any of which may incorporate computing devices, as defined in…
In vitro diagnostic test systems — Nucleic acid amplification-based examination procedures for detec...
This document describes the particular clinical laboratory practice requirements to ensure the quality of detection, identification and quantification of microbial pathogens using nucleic acid amplification tests (NAAT).
It is intended for use by laboratories that develop, and/or implement and use, or perform NAAT for medical, research or health-related purposes. This document does not apply to…
Mechanical vibration — Laboratory method for evaluating vehicle seat vibration — Part 1: Basic requi...
ISO 10326-1:2016 specifies basic requirements for the laboratory testing of vibration transmission through a vehicle seat to the occupant. These methods for measurement and analysis make it possible to compare test results from different laboratories for equivalent seats.
It specifies the test method, the instrumentation requirements, the measuring assessment method and the way to report the test…
This International Standard provides metrological and construction requirements for an internationally acceptable series of burettes, suitable for general laboratory purposes.
The details specified are in accordance with the principles of design and construction of volumetric glassware given in ISO 384.
For piston burettes, see ISO 8655-3.
ISO 4142:2002 specifies a range of test tubes, suitable for general laboratory use, fabricated from borosilicate, neutral or soda/lime glass, which are designated Type I, Type II and Type III respectively.
Laboratory glassware — Boiling flasks with conical ground joints
ISO 4797:2015 specifies requirements for an internationally acceptable series of boiling flasks with conical ground joints for general laboratory purposes.
Laboratory glassware — Boiling flasks with conical ground joints
ISO 4797:2004 specifies requirements for an internationally acceptable series of boiling flasks with conical ground joints for general laboratory purposes.
Geotechnical investigation and testing — Laboratory testing of soil — Part 1: Determination of water...
ISO/TS 17892-1:2004 specifies the laboratory determination of the water (moisture) content of a soil test specimen by oven-drying within the scope of the geotechnical investigations according to prEN 1997-1 and prEN 1997-2. The water content is required as a guide to classification of natural soils and as a control criterion in re-compacted soils and is measured on samples used for most field and…
Pulps — Preparation of laboratory sheets for the measurement of optical properties
This document specifies two procedures for the preparation of laboratory sheets prior to measuring optical properties. One is the preparation of pads in a Büchner funnel using a filter paper or a wire screen and the other one is the preparation of laboratory sheets in a standard sheet former (conventional or Rapid Köthen).
This document is applicable to all wood pulps and to most other types of…
