Typical horizontal joints between an external wall of prefabricated ordinary concrete components and...
For the determination of the watertightness of a joint a method has still not been elaborated. Because of the fundamental importance of this property, a solution is proposed, by way of an example, that experience and laboratory studies have shown to be satisfactory under the usual conditions. Is applicable to public or private buildings, used as dwellings, offices, educational or hospital…
Test method for assessing the performance of gas-phase air cleaning media and devices for general ve...
ISO 10121-1:2014 aims to provide an objective laboratory test method, a suggested apparatus, normative test sections and normative tests for evaluation of three different solid gas-phase air cleaning media (GPACM) or GPACM configurations for use in gas-phase air cleaning devices intended for general filtration applications. ISO 10121-1:2014 is specifically intended for challenge testing and not…
Road vehicles – Visibility – Requirements and recommendations for automotive interior display system...
The document concerns display systems, including their cover material, inside of a vehicle and with the purpose of providing vital information to the driver.
The display system may be located directly in front of the driver, in the middle section of the dashboard, or stretch from the driver’s side to the middle section. It relays information from the instrument cluster, navigation system,…
Implants for surgery — Partial and total hip joint prostheses — Part 12: Deformation test method for...
This part of ISO 7206 specifies a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions. It also defines the conditions of testing so that the important parameters that affect the components are taken into account and it describes how the specimen is set up for testing.
The described method is…
Meteorology — Radiosonde — Part 1: Laboratory test method for calibration error of temperature senso...
This International Standard proposal specifies technical requirements and test method for temperature sensor in radiosonde. This International Standard is applicable to the temperature measurement traceable to SI unit in boom sensors according to variations of pressure and air speed under the simulated conditions of upper air.
This proposed standard will mainly provide
a) Terms and definitions…
Measurement of radioactivity — Gamma emitting radionuclides — Rapid screening method using scintilla...
ISO 19581 specifies a screening test method to quantify rapidly the activity concentration of gamma-emitting radionuclides, such as 131I, 132Te, 134Cs and 137Cs, in solid or liquid test samples using gamma-ray spectrometry with lower resolution scintillation detectors as compared with the HPGe detectors (see IEC 61563).
This test method can be used for the measurement of any potentially…
Fans — Determination of fan sound power levels under standardized laboratory conditions — Part 1: Ge...
ISO 13347:2004 deals with the determination of the acoustic performance of industrial fans. In addition, it may be used to determine the acoustic performance of fans combined with an ancillary device such as a roof cowl or damper or, where the fan is fitted with a silencer, the sound power resulting from the fan and silencer combination.
