Rechercher

IEC TS 62257-9-5:2018 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. IEC TS 62257-9-5:2018 applies to stand-alone renewable energy products. This document deals essentially with off…

IEC TS 62257-9-5:2018 applies to stand-alone renewable energy products. This document deals essentially with off-grid renewable energy products with batteries and solar modules with DC system voltages not exceeding 35 V and peak power ratings not exceeding 350 W. The tests contained herein are capable in many cases of adequately assessing systems at higher voltages and/or power ratings. This new…

This document specifies requirements for sterile, single use drainage catheters, wound and fluid accumulation drainage systems, surgical drainage catheters and their components, where the catheter is placed in a body cavity or wound, surgically or percutaneously, for drainage of fluid or air to the exterior. The drainage catheter is left to drain naturally or connected to a suction source for…

This part of IEC 61000 for EMC immunity requirements applies to electrical and electronic equipment intended for use in industrial locations, as described below. Immunity requirements in the frequency range 0 Hz to 400 GHz are covered. No tests need to be performed at frequencies where no requirements are specified. This generic EMC immunity standard is applicable if no relevant dedicated…

B108-18, Part 1 Compressed natural gas refuelling stations installation code 1 Scope 1.1 Part 1 of this Code applies to all compressed natural gas refuelling stations, including those that are intended for fleet or public dispensing operations. 1.2 Part 1 of this Code does not apply to refuelling vehicles with liquefied natural gas (LNG). Refuelling vehicles with LNG is addressed in Part 2…

1 Scope 1.1 This security evaluation standard applies to the testing of network connected components of healthcare systems. It applies to, but is not limited to, the following key components: a) Medical devices; b) Accessories to medical devices; c) Medical device data systems; d) In vitro diagnostic devices; e) Health information technology; and f) Wellness devices.

IEC 61010-031:2015+A1:2018 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a…

This document gives general and dimensional specifications for flanged heads, flange clamps, ports and mounting surfaces applicable to four-screw, one-piece square flange clamp type tube connectors and hose fittings for use at a pressure of 42 MPa [420 bar[1]]. It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals. These connections are intended for…

IEC 61010-031:2015+A1:2018 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a…

IEC 60335-2-6:2014+A1:2018 deals with the safety of stationary electric cooking ranges, hobs, ovens and similar appliances for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral, and 480 V for other appliances. This International Standard also includes some requirements for ovens that are intended to be used on board…