Rechercher

Scope 1.1 Structures, systems, and components requiring seismic qualification This Standard defines the processes and requirements for performing seismic qualification by testing and presents the test methods that may be used for the seismic qualification of the nuclear power plant structures, systems, and components (SSCs). Seismic qualification by testing is typically used for SSCs that…

Scope 1.1 This Standard covers requirements for devices to detect certain out of parameter conditions of supply voltage and/or load current and mitigate, by circuit interruption, the effects of (a) overload within utilization equipment; or (b) over- or under-voltage, or both, that can pose a risk of fire ignition under certain conditions. These devices are to be incorporated in certified (end…

Scope 1.1 This Standard specifies methods for measuring electrical power consumption of equipment intended for use in commercial and industrial application when in low power mode(s) (i.e., standby mode, off mode, and network mode) and idle mode. This Standard is applicable to electrical products with a rated input voltage or voltage range that lies wholly or partly in the range 100 V a.c. to…

Scope 1.1 This Standard specifies efficiency values for dry-type transformers. The total ownership cost (TOC) methodology is recommended as the means for achieving these efficiencies, particularly for electric utilities. This Standard also specifies an optimal method for users other than utilities, based on a modified TOC methodology that meets the conditions of energy cost. Note: See Table 1…

Scope 1.1 This Standard specifies test procedures and performance requirements for screw-based general service lamps that are designed for an operating capability that partially falls within 100 and 130 V. 1.2 This Standard does not include requirements for luminaires used with general service lamps. 1.3 In CSA standards, "shall" is used to express a requirement, i.e., a provision…

Scope 1.1 This Standard applies to common types of portable ladders and includes design and performance-related requirements and tests. 1.2 Ladders covered by this Standard are intended for use by only one person at a time under normal conditions of usage, with the exception of trestle ladders, which are designed for use by two persons at the same time. 1.3 This Standard does not…

Scope 1.1 This Standard provides definitions, classifications, and a method for determining calculated daily energy consumption (CDEC) values and specifies minimum energy efficiency requirements for refrigerated display cabinets. 1.2 This Standard applies to the refrigerated display cabinets (with or without an integral refrigerated storage cabinet) that are described in Clause 4 and intended…

1 Scope 1.1 This Standard specifies the technical requirements for the design, procurement, fabrication, installation, modification, repair, replacement, testing, examination, and inspection of, and other work related to, pressure-retaining systems, components, and supports over the service life of a CANDU nuclear power plant. 1.2 This Standard applies to all pressure-retaining systems,…

This part of ISO 10295 provides guidance in respect of a structured method of characterizing the penetrating seal under test utilizing a series of defined parameters, each one being determined by the use of a selected series of test configurations in conjunction with simulated services. The level of characterization being sought is dependent upon the classification requirement of the system,…

This International Standard defines the most important quantities that characterize an energy-dispersive X-ray spectrometer consisting of a semiconductor detector, a pre-amplifier and a signal-processing unit as the essential parts. This International Standard is only applicable to spectrometers with semiconductor detectors operating on the principle of solid-state ionization. This International…