Rechercher

ISO 10161:2014 defines the protocol for an ILL application-service-element (ASE). It specifies the behaviour which must be exhibited by a system in order to take part in the provision of the ISO interlibrary loan service. It provides a formal statement of the rules of behaviour of each of the two or more entities participating in an ILL transaction. It specifies a) the actions to be taken on…

1.1 This Standard applies to mineral fibre thermal insulation manufactured in the form of faced and unfaced batts, rolls and boards. Where facings are used, they shall be either permeable or vapour retarding membranes, as defined in TABLE 1 for Types 2 and 3, respectively. This standard does not permit the application of kraft paper facings on batts and rolls. It also applies to loose fill…

1.1 This Standard covers electrical safety requirements for 120 V cord-connected single circuit wiring systems for residential and commercial use and for use with free standing interconnected tables, provided with communication, video, and/or power receptacles that are intended for frequent setup and breakdown. 1.2 The requirements apply to powered tables connected to 15 A or 20 A, 120 V (…

1.1 Scope of this Standard This Standard specifies requirements pertaining to the following: (a) definitions; (b) construction; (c) equipment complying with Standards; (d) safety and protection; (e) materials and quality of work; (f) marking; and (g) tests (of a general nature). Such requirements are applicable to all individual Standards of the Canadian Electrical Code, Part II (see…

1 Scope 1.1 This Standard establishes criteria for emergency preparedness and response for the petroleum and natural gas industry systems. Note: Prevention, continuity, and recovery are not within the scope of this Standard. 1.2 This Standard applies to petroleum and natural gas industry systems (see Figures 1 and 2), including a) pipeline systems handling i) oil; ii) gas; iii) oil-…

1 Scope 1.1 This Standard applies to surge protective devices (SPDs) intended for: a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up to 750 V ac; c) installation between the secondary of the service transformer and the line side of the service equipment overcurrent protective device. These…

1 Scope 1.1 This Standard covers the manufacturing process and testing requirements of fibre-reinforced polymer (FRP) wet layup composite systems, pre-cured FRP plates, and FRP bars externally bonded as structural strengthening materials for structures (concrete, steel, wood, and masonry). 1.2 This Standard covers FRPs comprised of a) glass, carbon, or aramid fibres; and b) isophthalic…

1 SCOPE 1.1 This Standard applies to mineral fibre thermal insulation manufactured in the form of faced and unfaced batts, rolls and boards. Where facings are used, they shall be either permeable or vapour retarding membranes, as defined in Table 1 for Types 2 and 3, respectively. This standard does not permit the application of kraft paper facings on batts and rolls. It also applies to loose…

ISO 10370:2014 specifies a method for the determination of the amount of carbon residue, in the range 0,10 % (m/m) to 30,0 % (m/m), left after evaporation and pyrolysis of petroleum products under specified conditions. NOTE 1 The carbon residue value serves as an approximation of the tendency of petroleum products to form carbonaceous deposits under similar degradation conditions, and may…

ISO 18613:2014 specifies the maximum defects and damage allowed before a flat wooden pallet shall be repaired, and defines the minimum repair criteria that shall be used. ISO 18613:2014 is applicable to wooden flat pallets repaired with wood based components.