Emergency preparedness and response for petroleum and natural gas industry systems
1 Scope
1.1
This Standard establishes criteria for emergency preparedness and response for the petroleum and natural gas industry systems.
Note: Prevention, continuity, and recovery are not within the scope of this Standard.
1.2
This Standard applies to petroleum and natural gas industry systems (see Figures 1 and 2), including
a)
pipeline systems handling
i)
oil;
ii)
gas;
iii)
oil-…
Surge protective devices — Type 1 — Permanently connected
1 Scope
1.1
This Standard applies to surge protective devices (SPDs) intended for:
a)
permanently connected applications designed for limiting surge voltages and discharging surge currents;
b)
use on 50/60 Hz circuits over 42 V and up to 750 V ac;
c)
installation between the secondary of the service transformer and the line side of the service equipment overcurrent protective device. These…
Specification for fibre-reinforced polymer (FRP) materials for externally reinforcing structures
1 Scope
1.1
This Standard covers the manufacturing process and testing requirements of fibre-reinforced polymer (FRP) wet layup composite systems, pre-cured FRP plates, and FRP bars externally bonded as structural strengthening materials for structures (concrete, steel, wood, and masonry).
1.2
This Standard covers FRPs comprised of
a)
glass, carbon, or aramid fibres; and
b)
isophthalic…
STANDARD FOR MINERAL FIBRE THERMAL INSULATION FOR BUILDINGS
1 SCOPE
1.1 This Standard applies to mineral fibre thermal insulation manufactured in the form of faced and
unfaced batts, rolls and boards. Where facings are used, they shall be either permeable or vapour
retarding membranes, as defined in Table 1 for Types 2 and 3, respectively. This standard does not permit
the application of kraft paper facings on batts and rolls. It also applies to loose…
Petroleum products — Determination of carbon residue — Micro method
ISO 10370:2014 specifies a method for the determination of the amount of carbon residue, in the range 0,10 % (m/m) to 30,0 % (m/m), left after evaporation and pyrolysis of petroleum products under specified conditions.
NOTE 1 The carbon residue value serves as an approximation of the tendency of petroleum products to form carbonaceous deposits under similar degradation conditions, and may…
Pallets for materials handling — Repair of flat wooden pallets
ISO 18613:2014 specifies the maximum defects and damage allowed before a flat wooden pallet shall be repaired, and defines the minimum repair criteria that shall be used.
ISO 18613:2014 is applicable to wooden flat pallets repaired with wood based components.
Electronic Fee Collection (EFC) — Interface definition between DSRC-OBE and external in-vehicle devi...
ISO/TS 16785:2014 defines an application interface between DSRC-based OBE and external in-vehicle devices to make DSRC-OBE applicable for diversified tolling environment.
Information technology — Storage management — Part 1: Overview
ISO/IEC 24775-1:2014(E) defines an interface for the secure, extensible, and interoperable management of a distributed and heterogeneous storage system. This interface uses an object-oriented, XML-based, messaging-based protocol designed to support the specific requirements of managing devices and subsystems in this storage environment. Using this protocol, this part of ISO/IEC 24775 describes…
Information technology — Storage management — Part 2: Common Architecture
ISO/IEC 24775-2:2014(E) defines the core architecture and protocols in SMI-S. The components of SMI-S architecture include:
- Transport - communicating management information between constituents of the management system;
- Health and fault management - detecting failures through monitoring the state of storage components;
- General information about…
Information technology — Storage management — Part 3: Common Profiles
ISO/IEC 24775-3:2014(E) defines profiles that are supported by profiles defined in the other parts of the ISO/IEC 24775 series. The first few clauses provide background material that helps explain the purpose and profiles and recipes (a subset of a profile). Common port profiles are grouped together since they serve as transport-specific variations of a common model. The port profiles are…
