Sterilization of health care products — Radiation — Part 2:Establishing the sterilization dose
This part of ISO 11137 specifies methods for determining the minimum dose needed to achieve a specified
requirement for sterility and methods to substantiate the use of 25 kGy or 15 kGy as the sterilization
dose to achieve a sterility assurance level, SAL, of 10-6. This part of ISO 11137 also specifies methods of
sterilization dose audit used to demonstrate the continued effectiveness of the…
1.1
This Standard applies to wet-process porcelain and toughened glass suspension-type insulators used on ac overhead power lines with a nominal voltage greater than 1000 V and a frequency not greater than 100 Hz.
This Standard applies to single insulator units only and does not apply to long rod insulators.
1.2
This Standard specifies provisions for
a)
the mechanical, electrical, and…
Dead-end/suspension composite insulators for overhead lines = 75 kV For
1.1
This Standard covers the requirements for dead-end/suspension composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Dead-end insulators support the line conductor horizontally. Suspension insulators support the line conductor vertically. Both are subjected to tensile and torsional loads.
These composite insulators are intended to…
Line post composite insulators for overhead distribution lines = 75 kV
1.1
This Standard covers the requirements for line post composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Line post insulators support the line conductor horizontally or vertically. They are subjected to tensile, cantilever, and compressive loads.
These composite insulators are intended to operate in a service environment within a…
ISO 10254:2016 defines the terms relating to air cargo and aircraft ground equipment, as used in the other International Standards in these areas.
NOTE The term "weight" is used throughout ISO 10254:2016 instead of the correct technical term "mass", in order to conform to current commercial usage.
The terms and abridged definitions of ISO 10254:2016 are primarily…
Timber structures — Determination of characteristic values — Part 3: Glued laminated timber
ISO 12122-3:2016 gives methods for the determination of characteristic values for a defined population of glued laminated timber products, calculated from test values.
It presents methods for the determination of
a) characteristic value of mean-based properties, and
b) characteristic value of 5th percentile-based properties.
NOTE Annex B gives information on the methods that have…
Metallic materials — Tensile testing — Part 1: Method of test at room temperature
ISO 6892-1:2016 specifies the method for tensile testing of metallic materials and defines the mechanical properties which can be determined at room temperature.
NOTE Annex A contains further recommendations for computer controlled testing machines.
Information technology — Reference Architecture for Service Oriented Architecture (SOA RA) — Part 3:...
ISO/IEC 18384-3:2016 defines a formal ontology for service-oriented architecture (SOA), an architectural style that supports service orientation. The terms defined in this ontology are key terms from the vocabulary in ISO/IEC 18384-1.
Information technology - Reference Architecture for Service Oriented Architecture (SOA RA) - Part 3:...
ISO/IEC 18384-3:2016 defines a formal ontology for service-oriented architecture (SOA), an architectural style that supports service orientation. The terms defined in this ontology are key terms from the vocabulary in ISO/IEC 18384-1.
High-voltage test techniques for low-voltage equipment - Definitions, test and procedure requirement...
IEC 61180:2016 is applicable to dielectric tests with direct voltage; dielectric tests with alternating voltage; dielectric tests with impulse voltage and test equipment used for dielectric tests on low-voltage equipment. This standard is applicable only to tests on equipment having a rated voltage of not more than 1 kV a.c. or 1,5 kV d.c. This standard is applicable to type and routine tests for…
