Enterprise-control system integration - Part 6: Messaging Service Model
IEC PAS 62264-6:2016(E) defines a model of a set of messaging services for information exchanges across Levels 3 and 4, and within Level 3, between applications performing business and manufacturing activities. It defines a standard interface for information exchange between systems.
Information technology — Security techniques — Cryptographic techniques based on elliptic curves — P...
ISO/IEC 15946-1:2016 describes the mathematical background and general techniques necessary for implementing the elliptic curve cryptography mechanisms defined in ISO/IEC 15946‑5, ISO/IEC 9796‑3, ISO/IEC 11770‑3, ISO/IEC 14888‑3, ISO/IEC 18033‑2 and other ISO/IEC standards.
ISO/IEC 15946-1:2016 does not specify the implementation of the techniques it defines. For example, it does not specify the…
Information technology - Security techniques - Cryptographic techniques based on elliptic curves - P...
ISO/IEC 15946-1:2016 describes the mathematical background and general techniques necessary for implementing the elliptic curve cryptography mechanisms defined in ISO/IEC 15946‑5, ISO/IEC 9796‑3, ISO/IEC 11770‑3, ISO/IEC 14888‑3, ISO/IEC 18033‑2 and other ISO/IEC standards.
ISO/IEC 15946-1:2016 does not specify the implementation of the techniques it defines. For example, it does not specify the…
Road vehicles — Electrical disturbances from conduction and coupling — Part 3: Electrical transient ...
ISO 7637-3:2016 defines bench test methods to evaluate the immunity of devices under test (DUTs) to transient pulses coupled to lines other than supply lines. The test pulses simulate both fast and slow transient disturbances caused by the switching of inductive loads and relay contact bounce.
The following three test methods are described in ISO 7637-3:2016:
- capacitive coupling clamp (CCC…
Health informatics — Information security management in health using ISO/IEC 27002
ISO 27799:2016 gives guidelines for organizational information security standards and information security management practices including the selection, implementation and management of controls taking into consideration the organization's information security risk environment(s).
It defines guidelines to support the interpretation and implementation in health informatics of ISO/IEC 27002…
Composite suspension insulators for overhead lines > 75 kV
1.1
This Standard applies to suspension and dead-end composite insulators used on ac overhead transmission lines with a nominal voltage greater than 75 kV and a frequency not greater than 100 Hz.
1.2
This Standard specifies
a)
insulator characteristics (mechanical, electrical, and dimensional) and prescribe the conditions under which these characteristics are to be verified;
b)
test…
1.1
This Standard covers the requirements for guy composite insulators used in guy wires on overhead distribution lines operating at nominal voltages up to and including 75 kV. Guy insulators insulate or isolate guy wires for corrosion protection, higher insulation levels, clearances for maintenance and normal operation, and safety for the public and workers (joint-use). Guy composite insulators…
1.1
This Standard applies to mechanical flue-gas exhausters intended to be installed in a flue pipe,
breeching, or chimney and serving appliances burning natural gas, propane, or fuel oil.
1.2
This Standard covers the mechanical and electrical features of mechanical flue-gas exhausters for indoor
or outdoor installations.
1.3
This Standard classifies mechanical flue-gas exhausters as:
a)…
Reduction of fugitive and vented emissions for upstream petroleum and natural gas industry systems
1.1
This Standard specifies criteria to develop emission reduction practices and programs.
1.2
This Standard addresses fugitive and vented emissions from point sources in the following sectors (see
Figure 1) of the upstream oil and gas industry from wells, pipelines, and facilities associated with
a) crude oil production and shale oil;
b) oil sands – in situ bitumen production, including…
