Rechercher

ISO 14513:2016 specifies a test method to simulate the head impact of an adult pedestrian to the bonnet top of passenger vehicles or light truck vehicles of up to 3,5 t (GVM), as defined in ISO 3833. The impact device to be used in this test method will be robust for a vehicle impact velocity of up to 11 m/s. The test method specified addresses the reduction of an adult pedestrian head injury…

ISO 10924-1:2016 defines terms and specifies general test requirements for circuit breakers for use in road vehicles with a nominal voltage of 12 V d.c., 24 V d.c, 48 V d.c. and 450 V d.c. ISO 10924-1:2016 is intended to be used in conjunction with other parts of ISO 10924. The numbering of its clauses corresponds to that of this part of ISO 10924 whose requirements are applicable, except where…

1.1 Inclusions This Standard is intended to be used for compressed air systems with the following characteristics: a) electrically driven three-phase air compressors equal to or greater than 5 horsepower; b) positive displacement stationary air compressors and associated equipment; c) operating pressures between 2.5 and 17 bar(g) (36 and 250 psi(g)); and d) industrial and commercial…

1.1 This Standard describes the technical requirements and procedures necessary for the design, performance, and testing of new or unused flameproof, non-rail-bound diesel-powered, self-propelled machines for use in gassy underground mines. Note: The working environment of gassy mines is characterized by the presence of methane gas and combustible dust. 1.2 This Standard applies to…

1.1 This Standard describes the technical requirements and procedures necessary for the design, performance and testing of new or unused non-rail-bound, diesel-powered, self-propelled machines for use in non-gassy underground mines. 1.2 This Standard applies to machines of 45 000 kg mass or less, which are designed to operate on level ground at a maximum speed of 32 km/h or less. 1.3…

1.1 General This Standard details mechanical, physical, and electrical requirements for a newly manufactured appliance that dispenses natural gas for vehicles directly into the vehicle natural gas fuel storage system, referred to as a residential fueling appliance (RFA). 1.2 Application These requirements apply to appliances: a) for natural gas only (see Clause 1.1); b) for outdoor or…

1.1 This Standard applies to modular wiring systems combined with the office furniture in which they are intended to be used. 1.2 This Standard applies to equipment intended to be permanently connected to one or more supply circuits at a nominal system voltage of 120 V to ground, and a rating of 15 or 20 A maximum per circuit, for use in nonhazardous locations, in accordance with the Rules of…

1.1 This Standard applies to a Type FCC under-carpet wiring system utilizing cable that is installed under carpet squares that are removable, and associated accessories, intended for use in accordance with the Rules of the Canadian Electrical Code, Part I. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply…

1.1 This Standard applies to plumbing products with electrical features rated not more than 150 V to ground. The equipment specified in this Standard is intended for installation in accordance with CSA C22.1 Canadian Electrical Code, Part I. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard…

1.1 This Standard applies to all ballasts for high-intensity discharge (HID) and low-pressure sodium (LPS) lamps intended to operate with an input line frequency of 60 Hz. Note: Safety requirements for ballasts are provided in Part 2 of CAN/CSA-C22.2 No. 74. 1.2 This Standard defines the measurement technique for determining the efficiency of HID and LPS lamp ballasts for use in HID and LPS…