Rechercher

1.1 This Standard specifies criteria for establishing a security management program for petroleum and natural gas industry systems to ensure security threats and associated risks are identified and managed. This Standard provides mitigation and response processes and procedures to prevent and minimize the impact of security incidents that could adversely affect people, the environment, assets…

1.1 This Standard applies to newly produced, direct gas-fired process air heaters of the recirculating or non- recirculating type (see Clause 3, Definitions), hereinafter referred to as heaters, whose primary purpose is to provide process heating to non-occupied spaces within commercial and industrial buildings and may also include operation as a non-recirculating ventilation air heater (see…

1.1 This Standard covers component assembly surge protective devices (SPDs) consisting of two or more Type 5 components, intended for use in Type 1, 2, or 3 SPD applications or installation in other electrical equipment. Note: SPD components containing integral thermal devices are within the scope of CSA C22.2 No. 269.5. 1.2 Type 4 component assemblies are designed for repeated limiting of…

1.1 These requirements cover in-ground boxes with integral electrical enclosure(s) for housing wiring devices connected to a branch circuit. The unit is intended to be installed outdoors and in the ground. The unit provides access to one or more receptacle outlets and is intended to be installed in accordance with NFPA 70, National Electrical Code, CSA C22.1, Canadian Electrical Code, Part I,…

1.1 This Standard covers plastic plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings. 1.2 This Standard covers the following plumbing fixtures: a) bathtubs and combination tub/showers; b) lavatories; c) shower bases and shower stalls; d) sinks: i) bar sinks; ii) kitchen sinks; iii) laundry sinks; and iv) service sinks; e…

1.1 This Standard establishes requirements for area measurement in health care facilities (HCFs). It is intended to provide a basic, uniform system to a) support HCF planning and design activities that require such measurements (e.g., functional programming, building and room design, administration, cost estimating, and funding of capital programs); and b) facilitate meaningful comparisons…

1.1 This Standard applies to newly produced, non-recirculating direct gas-fired heating and forced ventilation appliances, hereinafter referred to as heaters, whose purpose is to address building infiltration, replace building air that is exhausted, offset building conduction heat loss and provide outside air ventilation. All air to the heater is ducted directly from outdoors and the products of…

1.1 General This Standard contains performance requirements for the material, design, marking, and testing of serially produced, refillable containers intended only for the storage of liquefied natural gas for medium- and heavy-duty vehicle operation. 1.2 Construction or materials All specifications as to construction or materials may be satisfied by any construction or materials that will…

1.1 This Standard applies to newly produced compressed Natural Gas Vehicle (NGV) fueling connection devices, hereinafter referred to as “devices”, constructed entirely of new, unused parts and materials. NGV fueling connection devices consist of the following components, as applicable: a) receptacle and protective cap (mounted on vehicle) (see Clause 4.4); b) nozzle (see Clause 4.2); and c…

1.1 This Standard applies to non-conductive optical fiber cable and conductive optical fiber cable intended to be installed indoors in non-hazardous locations in accordance with CSA C22.1, Canadian Electrical Code, Part I. This Standard provides performance requirements for products installed in accordance with Section 56 of the Canadian Electrical Code, Part I. 1.2 This Standard does not…