Rechercher

ISO 12619-6:2017 specifies tests and requirements for the automatic valve, a compressed gaseous hydrogen (CGH2) and hydrogen/natural gas blends fuel system component intended for use on the types of motor vehicles defined in ISO 3833. It is applicable to vehicles using compressed gaseous hydrogen (CGH2) in accordance with ISO 14687‑1 or ISO 14687‑2 and hydrogen/natural gas blends using natural…

ISO 12614-19:2017 specifies tests and requirements for the automatic valve, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This document is applicable to vehicles using natural gas in accordance with ISO 15403 (all parts) (mono-fuel, bi-fuel or dual-fuel applications). It is not applicable to the following: a) fuel containers…

IEC 61400-12-1:2017 specifies a procedure for measuring the power performance characteristics of a single wind turbine and applies to the testing of wind turbines of all types and sizes connected to the electrical power network. In addition, this standard describes a procedure to be used to determine the power performance characteristics of small wind turbines (as defined in IEC 61400-2) when…

ISO 14917:2017 defines processes and general terms for thermal spraying. It classifies thermal spraying processes according to type of spray material, to type of operation and to type of energy carrier. It specifies abbreviations for spray processes, sprayed coatings, and manufacturing steps.

1.1 This Standard covers plumbing fixtures made of stainless steel alloys and specifies requirements for materials, construction, performance, testing, and markings. Note: The term “corrosion-resisting steel” is also applied to stainless steel. 1.2 This Standard covers the following plumbing fixtures: a) bathtubs; b) bidets; c) drinking fountains and water coolers; d) lavatories; e…

1.1 Application This Standard specifies requirements for the selection and installation of backflow preventers. Additional information on how backflow due to back siphonage and back pressure occurs, and how to select and apply specific devices, is included in Annexes A, B, and C. 1.2 Exclusions 1.2.1 This Standard does not specify requirements for materials, construction, or performance tests…

1.1 This Standard specifies criteria for establishing a security management program for petroleum and natural gas industry systems to ensure security threats and associated risks are identified and managed. This Standard provides mitigation and response processes and procedures to prevent and minimize the impact of security incidents that could adversely affect people, the environment, assets…

1.1 This Standard applies to newly produced, direct gas-fired process air heaters of the recirculating or non- recirculating type (see Clause 3, Definitions), hereinafter referred to as heaters, whose primary purpose is to provide process heating to non-occupied spaces within commercial and industrial buildings and may also include operation as a non-recirculating ventilation air heater (see…

1.1 This Standard covers component assembly surge protective devices (SPDs) consisting of two or more Type 5 components, intended for use in Type 1, 2, or 3 SPD applications or installation in other electrical equipment. Note: SPD components containing integral thermal devices are within the scope of CSA C22.2 No. 269.5. 1.2 Type 4 component assemblies are designed for repeated limiting of…

1.1 These requirements cover in-ground boxes with integral electrical enclosure(s) for housing wiring devices connected to a branch circuit. The unit is intended to be installed outdoors and in the ground. The unit provides access to one or more receptacle outlets and is intended to be installed in accordance with NFPA 70, National Electrical Code, CSA C22.1, Canadian Electrical Code, Part I,…