Rechercher

ISO 11295:2017 defines and describes families of techniques for the renovation and trenchless replacement (on or off the line of an existing pipeline) of non-pressure and pressure pipelines through the use of plastics pipes, including plastics composites formed in situ into pipes, fittings and ancillary components. It does not include new construction provided as network extension. For each…

ISO 4259-1:2017 specifies the methodology for the design of an Interlaboratory Study (ILS) and calculation of precision estimates of a test method specified by the study. In particular, it defines the relevant statistical terms (Clause 3), the procedures to be adopted in the planning of ILS to determine the precision of a test method (Clause 4), and the method of calculating the precision from…

ISO 4259-2:2017 specifies the methodology for the application of precision estimates of a test method derived from ISO 4259‑1. In particular, it defines the procedures for setting the property specification limits based upon test method precision where the property is determined using a specific test method, and in determining the specification conformance status when there are conflicting…

ISO/IEC TS 33073:2017: - defines an integrated PRM and PAM that meets the requirements of ISO/IEC 33004 and that supports the performance of an assessment by providing indicators for guidance on the interpretation of the process purposes and outcomes and the process attributes as defined in ISO/IEC 33020; - provides guidance, by example, on the definition, selection and use of…

1.1 This Standard specifies energy efficiency and performance requirements for LED luminaires of the directional and non-directional type used for general illumination, including commercial and residential, indoor and outdoor, as well as those with a significant decorative function. Notes: 1) White tunable luminaires and connected luminaires are included in the scope of this Standard. 2)…

This clause of Part 1 is applicable except as follows: 1.1 Scope Replacement: This part of IEC 60730 applies to automatic electrical pressure sensing controls with a minimum gauge pressure rating of –60 kPa and a maximum gauge pressure rating of 4,2 MPa, for use in, on or in association with, equipment. The equipment may use electricity, gas, oil, solid fuel, solar thermal energy, etc. or a…

1.1 This Standard applies to newly produced Type 1 clothes dryers (see Clause 3, Definitions), hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed gas; d) for use with propane gas; e) for use with LP gas-air mixtures; and f) for mobile home installation (see…

1.1 This Standard applies to newly produced, direct-fired construction heaters, hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration, or repair. All the products of combustion generated by the heater are released into the area being…

1 Scope 1.1 This Standard applies to newly produced, gas-fired high-intensity infrared heaters (see Clause 3, Definitions), hereinafter referred to as heaters or appliances, constructed entirely of new, unused parts and materials with inputs up to and including 400,000 Btu per hour (117 228 W) per burner: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed…

1.1 This Standard applies to single- and multi-conductor Type TECK 90 armoured cable intended for installation in accordance with the Canadian Electrical Code, Part I, on systems having nominal voltages of 5000 V and less and having a maximum temperature rating of 90 °C in both dry and wet locations. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the…