Rechercher

This document specifies a method of test for evaluating the appearance of apparel and other textile end products after one or several domestic washing and drying treatments. The appearance evaluated includes colour change, pilling, fuzzing, matting appearance of fabrics, smoothness appearance of flat fabric and seams, and the retention of pressed-in creases in garments and other textile products…

This document defines standardized and repeatable test procedures by using internal combustion engines for the evaluation of blowby oil aerosol, and aerosol separators and filtering devices by specifying the engine blowby sampling procedure and engine fractional efficiency test in both open and closed crankcase ventilation systems running at steady state. Due to sampling requirements, measuring…

1 Scope 1.1 This Standard sets out requirements for the selection, use, and care of respirators and for the administration of an effective respiratory protection program in the workplace. 1.2 This Standard is applicable to the selection, use, and care of respirators for non-emergency and emergency situations. 1.3 This Standard is not intended to address the selection of a) respirators for…

1 Scope 1.1 This Standard describes methods for determining the occupational noise exposure level of workers (Lex,T) using sampling techniques. Lex,T represents the long-term noise exposure of workers and is calculated from measurements of Leq,t (3 dB exchange rate) in the workplace. Notes: 1) The methods in this Standard are based on established definitions, units, instrumentation, and…

1 Scope This document establishes five modes of operation for applications of an n-bit block cipher (e.g.protection of data during transmission or in storage). The defined modes only provide protection of data confidentiality. Protection of data integrity is not within the scope of this document. Also, most modes do not protect the confidentiality of message length information. NOTE 1 Methods…

1 Scope This standard defines the protocol layer of the Serial Attached SCSI (SAS) interconnect and three transport protocols that use the SAS interconnect: a) Serial SCSI Protocol (SSP): a mapping of SCSI supporting multiple initiators and targets; b) Serial ATA Tunneled Protocol (STP): a mapping of Serial ATA expanded to support multiple initiators and targets; and c) Serial Management…

1 Scope This part of ISO/IEC 14776 defines the command set extensions to facilitate operation of SCSI direct access block devices. The clauses in this standard, implemented in conjunction with the applicable clauses of SPC-4, specify the standard command set for SCSI direct access block devices. The objectives of this standard are to: a) permit an application client to communicate over a…

1 Scope ISO/IEC 18013 establishes guidelines for the design format and data content of an ISO-compliant driving licence (IDL) with regard to human-readable features (ISO/IEC 18013-1), ISO machine-readable technologies (ISO/IEC 18013-2), and access control, authentication and integrity validation (ISO/IEC 18013-3). It creates a common basis for international use and mutual recognition of the…

1 Scope This part of ISO/IEC 18013 specifies the test methods used for conformity testing, that is methods for determining whether a driving licence can be considered to comply with the requirements of ISO/IEC 18013 for: ? machine-readable technologies (ISO/IEC 18013-2), and ? access control, authentication and integrity validation (ISO/IEC 18013-3). The test methods specified in this part of…

1 Scope This document defines the methods and general principles capable of describing codec configurations in the reconfigurable video coding (RVC) framework. It primarily addresses reconfigurable video aspects and will only focus on the description of representation for video codec configurations within the RVC framework. Within the scope of the RVC framework, two languages, namely FNL and…