Rechercher

1 Scope 1.1 This Standard applies to single- and multiple-conductor fire alarm and signal cables with a maximum nominal voltage rating of 300 V and a minimum temperature rating of 60 °C for use in buildings and other structures in dry, damp, or wet locations in accordance with the Canadian Electrical Code, Part I. 1.2 Because other CSA Group Standards specify requirements for certain…

1 Scope 1.1 This Standard specifies energy performance requirements for self-contained, refrigerated bottled, or canned beverage vending machines that actively cool bottled, canned, or other sealed refrigerated beverages. 1.2 This Standard specifies a) uniform procedures for measuring energy consumption; b) maximum daily energy consumption levels; and c) refrigerated volume, vending…

1 Scope 1.1 This Standard specifies the electrical, mechanical, dimensional characteristics, test methods, and acceptance criteria for composite station post insulators for outdoor service, operating at nominal voltages greater than 1000 V and frequency not greater than 100 Hz. Station post insulators are mainly used as support or operating elements in switching equipment, or as bus bar or…

1 Scope 1.1 This Standard addresses the following aspects of cementitious materials: a) their definitions; b) their chemical, physical, and uniformity requirements; c) the tests required; d) the procedures for inspection and sampling; and e) the units of measurement, packaging, marking, and storage. 1.2 The cementitious materials for use in concrete are classified as follows in this…

1 Scope 1.1 This Standard applies to high density polyethylene (HDPE) conduit, HDPE conduit with conductors, and polyethylene dual-wall (PEDW) corrugated conduit, intended for use at a continuous operating temperature of 75 °C or 90 °C, for installation in accordance with the Rules of the Canadian Electrical Code, Part I, for direct burial or encasement in concrete or masonry in ordinary (non-…

1 Scope 1.1 This Standard applies to newly produced household cooking gas appliances (see Clause 3, Definitions), hereinafter referred to as units or appliances, constructed entirely of new, unused parts and materials. These appliances may be floor supported or built-in. 1.2 This Standard applies to household cooking gas appliances: a) for use with natural gas; b) for use with…

1 Scope 1.1 This Standard specifies the electrical, mechanical, dimensional characteristics, test methods, and acceptance criteria for solid-core and cavity core ceramic and glass type station post insulators for outdoor service in electrical installations or equipment operating with a rated voltage greater than 1000 V and a rated frequency not greater than 100 Hz. Note: Hollow core insulators…

This document provides guidelines for the life cycle management of systems and software, complementing the processes described in ISO/IEC/IEEE 15288 and ISO/IEC/IEEE 12207. This document: — addresses systems concepts and life cycle concepts, models, stages, processes, process application, key points of view, adaptation and use in various domains and by various disciplines; —…

This document provides guidelines for the life cycle management of systems and software, complementing the processes described in ISO/IEC/IEEE 15288 and ISO/IEC/IEEE 12207. This document: — addresses systems concepts and life cycle concepts, models, stages, processes, process application, key points of view, adaptation and use in various domains and by various disciplines; —…

This document establishes the specifications for the execution of static pile load tests in which a single pile is subjected to an axial static load in compression in order to define its load-displacement behaviour. This document is applicable to vertical piles as well as raking piles. All types of piles are covered by this document. The tests considered in this document are limited to maintained…