Rechercher

IEC 61784-3-12:2010+A1:2019 specifies a safety communication layer (services and protocol) based on CPF 12 of IEC 61784-2 and IEC 61158 Type 12. It identifies the principles for functional safety communications defined in IEC 61784-3 that are relevant for this safety communication layer. <strong>This consolidated version consists of the first edition (2010) and its amendment 1 (2019).…

IEC 61784-3-12:2010+A1:2019 specifies a safety communication layer (services and protocol) based on CPF 12 of IEC 61784-2 and IEC 61158 Type 12. It identifies the principles for functional safety communications defined in IEC 61784-3 that are relevant for this safety communication layer. This consolidated version consists of the first edition (2010) and its amendment 1 (2019). Therefore, no need…

This document specifies a systematic system for representing humanoids in a network-enabled 3D graphics and multimedia environment. Conceptually, each humanoid is an articulated character that can be embedded in different representation systems and animated using the facilities provided by the representation system. This document specifies the abstract form and structure of humanoids. Further,…

This document specifies a systematic system for representing humanoids in a network-enabled 3D graphics and multimedia environment. Conceptually, each humanoid is an articulated character that can be embedded in different representation systems and animated using the facilities provided by the representation system. This document specifies the abstract form and structure of humanoids. Further,…

This document provides design requirements and guidance for the manufacturers of electrical and electronic equipment for use in all kinds of mobile (including hand-held) agricultural machinery, forestry machinery, landscaping and gardening machinery [referred to hereafter as machine(s)]. The term machinery covers tractors and implements. This document gives tests for specific environmental…

1 Scope This part of IEC 61000 for EMC immunity requirements applies to electrical and electronic equipment intended for use in residential, commercial, public and light-industrial locations. Immunity requirements in the frequency range 0 Hz to 400 GHz are covered. No tests need to be performed at frequencies where no requirements are specified. This generic EMC immunity standard is…

1 Scope 1.1 This Standard gives minimum requirements for ventilators used in buildings which are designed to permit venting of unoccupied spaces to the exterior so as to minimize the unwanted accumulation of condensation, moisture, and excess heat in the building component or assembly. These include a) passive airflow ventilators for buildings; and b) mechanical (powered) airflow…

1 Scope This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric HEAT PUMPS, including SANITARY HOT WATER HEAT PUMPS, AIR CONDITIONERS, and DEHUMIDIFIERS incorporating motor-compressors and HYDRONIC FAN COILS UNITS, their maximum RATED VOLTAGES being not more than 250 V for single phase appliances and 600 V for all other appliances. PARTIAL…

1 Scope 1.1 This Standard applies to the design, installation, operation, maintenance, and testing of emergency generators and associated equipment for providing an emergency electrical power supply to electrical loads a) in buildings and facilities when the normal power supply fails and an emergency electrical power supply is required by the National Building Code of Canada (NBCC); and b)…

1 Scope 1.1 This Standard applies to newly produced vented gas fireplace heaters (see Clause 3, Definitions), hereinafter referred to as appliance(s), constructed entirely of new, unused parts and materials, and having input ratings up to and including 400,000 Btu/hr (117 228 W): a) for use with natural gas; b) for use with propane; c) direct vent appliances for manufactured home (USA…