Rechercher

This document defines the grades and the corresponding requirements for ausferritic spheroidal graphite cast irons. This document specifies five grades of ausferritic spheroidal graphite cast iron by a classification based on mechanical properties determined on machined test pieces prepared from: — separately cast samples, side-by-side cast or cast-on samples; — samples cut from a casting…

This document defines a process reference model for the domain of service management. The model specifies a process architecture for the domain and comprises a set of processes. Each process is described in terms of process purpose and outcomes. The process reference model in this document is directed at assessment sponsors and competent assessors who wish to select a model, and associated…

This document defines a process reference model for the domain of service management. The model specifies a process architecture for the domain and comprises a set of processes. Each process is described in terms of process purpose and outcomes. The process reference model in this document is directed at assessment sponsors and competent assessors who wish to select a model, and associated…

1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for illustrations of mobile cranes and Annex B for illustrations of parts of a mobile crane. 1.2 This Standard applies only to machines that have all of the following…

1.1 Compressor types This Standard applies to compressor seal vent gas from reciprocating compressor rod packings and centrifugal compressor seals, including any auxiliary and support systems that are required for proper operation of the packing or sealing system. The procedures considered in this Standard include compressor seal vent gas system tracing and alternate flow path identification,…

1.1 This Standard covers anti-siphon fill valves intended to be installed in water closet tanks. Note: In this Standard, anti-siphon fill valves are also referred to as “devices”. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that…

This Standard applies to ME EQUIPMENT and ME SYSTEMS that are intended to be installed or used in accordance with CSA C22.1, Canadian Electrical Code, Part I. This part of IEC 60601 applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of EXTERNAL PACEMAKERS powered by an INTERNAL ELECTRICAL POWER SOURCE, hereafter referred to as ME EQUIPMENT. This document applies to PATIENT CABLES as…

1.1 Inclusions This Standard is intended to be used with an industrial or commercial clean-water pumping system with the following characteristics: a) any application of electrically driven single- and multi-stage rotodynamic pumps; b) pumping systemc) all liquids with viscosity up to 25 cSt, provided that ANSI/HI 9.6.7 is used to correct the performance to 1 cSt. 1.2 Exclusions This…

1.1 This Standard specifies the methods for determining the uniform energy factor for electric storage tank water heaters and heat pump water heaters. 1.2 This Standard a) establishes minimum energy efficiency levels for electric storage tank water heaters and heat pump water heaters; and b) includes advanced test methods for cold climate ratings (see Annex B). 1.3 This Standard applies…

1.1 General This Standard specifies requirements to facilitate the application of ergonomics into ambulance design and describes a user-centred design (UCD) process for establishing additional ergonomic requirements, as necessary. The objective of applying ergonomics is to optimize overall system performance by ensuring human performance and safety requirements are balanced with engineering and…