Oxygenated automotive gasoline containing ethanol (E1-E10 and E11-E15)
This National Standard of Canada applies to two types of oxygenated gasoline, E1-E10 (“Type A”) and E11-E15
(“Type B”), to which no lead or phosphorus compounds have been added, and in which the oxygenate consists
essentially of ethanol. They are intended for use in spark-ignition engines under a wide range of climatic conditions.
Each type may be supplied in one of four grades which differ in…
Special requirements for plumbing installations in health care facilities
1 Scope
1.1 General
This Standard addresses the special requirements of plumbing systems pertinent to the design, construction, operation, and maintenance of health care facilities (HCFs). This Standard specifies requirements for the following in HCFs:
a)
water supply systems, including cold water systems and hot water systems;
b)
plumbing fixtures and fittings;
c)
drainage systems;
d)…
Cable management systems — Cable ties for electrical installations
1 Scope
This document specifies requirements for metallic, non-metallic and composite cable ties and their
associated fixing devices used for the management and support of wiring systems in electrical
installations.
1DV.1 D2 Modify Clause 1 by replacing the first paragraph with the following:
This Standard specifies requirements for metallic, non-metallic, and composite cable ties
and their…
1 Scope
1.1 Application
This Standard provides requirements and guidelines for the thermal simulation and calculation of thermal bridges in new and existing Part 3 and Part 9 buildings, as defined in the National Building Code of Canada (NBC). This Standard describes the requirements for simulating heat flow through building enclosures, and can be used to justify the opaque envelope U-values…
1 Scope
1.1 These requirements cover flexible metallic hose supplied with fittings on each end that facilitate
connection without twisting the hose. They have a corrugated metal core or a nonmetallic inner core which
are covered with a stainless steel braid. They have a nominal inside diameter of not more than 4 in (101
mm) intended for use in piping systems carrying compressed gases, such as…
1 Domaine d’application
1.1 Ces exigences couvrent les tuyaux flexibles métalliques fournis avec deux raccords, un à chaque
extrémité, qui facilitent le raccordement sans qu’il faille tordre le tuyau. Les tuyaux sont dotés d’un centre
en métal ondulé ou d’un centre intérieur non métallique recouvert d’une tresse en acier inoxydable. Leur
diamètre intérieur nominal ne dépasse pas 4 po (101 mm…
Characterization of radioactive waste and irradiated fuel
1 Scope
1.1 General
This Standard pertains to the characterization of radioactive waste and irradiated fuel. This Standard
a)
specifies the overall requirements for establishing and implementing a waste characterization strategy, program, and plan;
b)
specifies methodologies for the sampling and characterization of radioactive waste and irradiated fuel;
c)
provides guidance for the timing…
1 Scope
1.1
This Standard provides requirements and guidance on the structural design of new wastewater treatment plants, including buildings and liquid-containing tanks, from the point effluent enters the plant to the point of its discharge.
1.2
This Standard is written in support of the design process provided by the National Building Code of Canada, but includes additional requirements…
1 Scope
1.1
This Standard applies to automatically operating gas-fired central furnaces (see Clause 3), hereinafter
referred to as furnaces, for installation in residential, commercial, and industrial structures including
furnaces for direct vent, recreational vehicle, outdoor, and manufactured (mobile) homes. These
furnaces can include a cooling unit. All units are to be constructed…
