Rechercher

Part 1 of ISO 9714 specifies materials and mechanical properties, dimensions and marking requirements for the mentioned instruments made of stainless steel for use in orthopaedic surgery with bone screws as specified in ISO 5835. Instruments made of other materials and coatings may be included at a later revision. The interrelationship of International Standards dealing with bone screws and…

This National Standard of Canada is equivalent to International Standard ISo 3572:1976. It gives definitions of general terms for describing weaves, and defines the three basic weaves.

This National Standard of Canada is equivalent to International Standard ISo 8159:1987. It defines the principal terms used to describe the various forms into which textile fibres can be assembled, up to and including cabled yarns. It contains only terms of general application; terms and/or definitions which are specific to particular fibres (such as hemp, silk, textile glass, metal…

This National Standard of Canada is equivalent to International Standard ISO 9092:1988. It establishes a definition for nonwovens.

Gives values of both plain end tubes for general purpose use and precision tubes. Its purpose is to give guidance on the selection of sizes for all activities concerned with the standardization of steel tubes, both nationally and internationally, to serve as a ready reckoner and to avoid the use by different countries of different masses for a tube of the same size. It is not applicable to tubes…

Applies to the quality testing of microimages produced with a given micrographic system and allows to determine the potential legibility of documents recorded with that system. Annex A gives optional features for ISO test chart No. 1. This second edition cancels and replaces the first editions (ISO 435:1975 and ISO 446:1975), which have been merged into a single International Standard.

Specifies the majority of tolerances on dimensions used by ISO/TC 5/SC 1 in drawing up International Standards concerning steel tubes. Is intended for use as a basic document by all ISO technical committees concerned with the standardization of steel tubes. It cannot, therefore, be used as a standard for the definiton of a product. This second edition cancels and replaces the first edition (1977…

1. Scope 1.1 General This Standard establishes limits and methods of measurement of the immunity of radio and television broadcasting receivers and certain associated equipment to degradation of performance due to electromagnetic disturbances. 1.2 Applicability This Standard is applicable to immunity of two classes of equipment from degradation of performance resulting from…

General Introduction One of the key requirements before organizations can exchange administrative, commercial and transport information between their computers, without manual intervention, is agreement on the content and structure of the information to be transmitted. In EDIFACT, this is achieved by developing United Nations Standard Electronic Messages (UNSM's), for both national and…

This Technical Report specifies the characteristics, test methods and checking. Calcium silicate slabs for thermal insulation will be covered by a future international standard. The requirements relate to general appearance and finish, geometrical characteristics (nominal length and width, thickness, tolerances on dimensions and shape), nominal density, bending strength, thermal conductivity, non…