Rechercher

Specifies the characteristics of products with metric dimensions and thread sizes from M 1,6 up to and including M 12 and product grade A; includes specifications with reference to International Standards; tabulates thread sizes M 1,6 up to M 12 with nominal lengths from 2 mm up to 60 mm; gives an example for the designation.

Specifies the characteristics of products with metric dimensions and thread sizes from M 1,6 up to and including M 12 and product grade A; includes specifications with reference to International Standards; tabulates thread sizes M 1,6 up to M 12 with nominal lengths from 2 mm up to 60 mm; gives an example for the designation.

Specifies the characteristics of products with thread sizes from M 1,2 up to and including M 12 and product grade A; includes specifications with reference to International Standards; tabulates thread sizes M 1,2 up to M 12 with nominal lengths from 2 mm up to 60 mm; gives an example for the designation.

Specifies the characteristics of screws with thread sizes from ST 2,2, up to and including ST 9,5; includes specifications with reference to International Standards; gives an example for the designation.

Specifies the characteristics of screws with thread sizes from ST 2,2 up to and including ST 9,5; includes specifications with reference to International Standards; gives an example for the designation.

Specifies the characteristics of types C, F, H and Z with thread sizes form ST 2,2 up to and including ST 9,5; includes specifications with reference to International Standards; gives an example for the designation

This International Standard specifies the dimensions and location of the maximum projectable image area on 16 mm motion-picture prints intended for viewing on motion-picture projectors (see note 4).

This PDF includes GI #2 and Errata. 1. Scope and Introduction 1.1 This Standard is intended to cover the field of technical drawing practice. It applies primarily to end-product drawings, which usually consist of detail drawings, and assembly or subassembly drawings, but is not intended to fully cover other supplementary drawings such as check lists, schematic diagrams, electrical wiring…

1. Scope 1.1 This Standard covers the dc electrical installations not exceeding 50 V between conductors on boats. 1.2 This Standard applies to boats that are not required to be certificated by the Department of Transport. 1.3 The requirements of this Standard are based on CSA Standard C22.1, Canadian Electrical Code, Part I. Where no specific requirements are given herein those…

States the requirements for ethylene glycol base engine coolant concentrate. Caution - Manufacturers of some vehicles with aluminum engine components specify a coolant with added protection from aluminum corrosion in excess of what would be expected for a product to this standard. The vehicle Owner's Manual should be consulted for any specialized coolant requirements.