Rechercher

This International Standard specifies a method for the determination of the edgewise crush resistance of corrugated fibreboard. The force is applied in the direction of the flute axis. This method is applicable to single-wall (double-faced), double-wall, and triple-wall corrugated fibreboard. It may also be used to test samples taken from corrugated cases and other converted products. While the…

ISO 19108:2002 defines concepts for describing temporal characteristics of geographic information. It depends upon existing information technology standards for the interchange of temporal information. It provides a basis for defining temporal feature attributes, feature operations, and feature associations, and for defining the temporal aspects of metadata about geographic information. Since…

This International Standard specifies the essential characteristics for the installation of lighting and light signalling devices on motor vehicles with or without bodywork and with at least four wheels, intended for on-road use and having a maximum design speed of more than 25 km/h, and their trailers. It is not applicable to vehicles that run on rails, to agricultural or forestry tractors and…

This International Standard specifies the requirements for unplasticized poly(vinyl chloride) (PVC-U) pipes and fittings for soil and waste discharge (low and high temperature) inside buildings, as well as the system itself. It does not include buried pipework. It also specifies the test parameters for the test methods referred to in this International Standard. This International Standard is…

This International Standard specifies a system of classification of materials used in preformed gaskets for buildings. It applies to the following products: gaskets for use round the inside of door or window casings, i.e. weatherstripping (dynamic gaskets);gaskets for glazing (static gaskets);gaskets for use round infilling;gaskets for use between façade parts;gaskets for use between masonry…

ISO/TS 16528:2002 specifies the criteria and process for registration of boiler and pressure vessel Codes and Standards to promote international recognition, support safety and facilitate trade. ISO/TS 16528:2002 is not applicable to Codes and Standards for nuclear components, railway and marine boilers, gas cylinders or piping systems, and mechanical equipment, e.g. turbines and machinery…

The SCSI protocol is designed to provide an efficient peer-to-peer I/O bus with the maximum number of hosts and peripherals determined by the bus width (8 or 16). Data may be transferred asynchronously or synchronously at rates that depend primarily on device implementation and cable length. SCSI is an I/O interface that may be operated over a wide range of media and transfer rates. The…

This International Standard specifies the frame structures, the elements of procedures, the classes of procedures, the content and format of the general purpose Exchange Identification (XID) frame, and a means for resolution/negotiation of a data link layer address in switched environments for data communication systems using bit-oriented high-level data link control (HDLC) procedures. NOTE The…

ISO 14829 specifies the calculations to be carried out to determine the stability of a straddle carrier. The stability calculations specified in this International Standard are intended to ensure that users of straddle carriers have adequate information about the behaviour of these carriers under various operating conditions. Stability warning and control devices are not covered by this…

This International Standard specifies, for the field of air quality measurement procedures, the: estimation of measurement uncertainty from actual or claimed values of all important performance characteristics of a method under stationary conditions; assessment of whether or not specified values for these performance characteristics comply with the required quality of a measured value at a…