Rechercher

This document specifies minimum requirements for breathing sets and breathing tubes intended to be used with anaesthetic breathing systems, ventilator breathing systems, humidifiers or nebulizers. It applies to breathing sets and breathing tubes and patient end adaptors supplied already assembled and to those supplied as components and assembled in accordance with the manufacturer’s instructions…

Le présent document spécifie les exigences de base concernant les ensembles respiratoires et les tubes respiratoires destinés à être utilisés avec des systèmes d’anesthésie par voie respiratoire, des systèmes respiratoires de ventilateurs, des humidificateurs ou des nébuliseurs. Il s’applique aux ensembles respiratoires, aux tubes respiratoires et aux adaptateurs d’extrémité «patient» fournis…

This document gives guidance and requirements for the assessment of conformity of compounds, products, joints and assemblies in accordance with the applicable part(s) of the ISO 16486 series which are intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of certification procedures. NOTE 1    A basic test matrix in Annex B…

This document establishes formulae for the calculation of power rating and centre distance of standard synchronous belts on two pulley drives. It is applicable to trapezoidal belts only. It does not apply to curvilinear synchronous belts. The numerical values of certain parameters used in the calculations depend upon the pitch and the construction of the belt and are specified by the belt…

Le présent document spécifie les exigences relatives aux contrôles et essais périodiques des bouteilles et tubes à gaz en matériau composite transportables, frettés ou entièrement bobinés, dotés ou non d’un liner en alliage d’aluminium, en acier ou non métallique (Types 2, 3, 4 et 5), destinés à contenir des gaz comprimés, liquéfiés ou dissous sous pression et ayant une contenance en eau comprise…

This document provides a method for evaluating the resonance vibration frequency of the multi-copter unmanned aircraft (UA). This document specifies a method of designing the UA so as to avoid the resonance generated by the coincidence of the natural frequency of the UA body and the rotational frequency of the rotor. This document is applicable to multi-copter UA weighing less than 150 kg.

This document specifies the requirements for periodic inspection and testing to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity…

Automated valet parking systems (AVPSs) perform level 4 automated driving of individual or multiple unoccupied vehicles within a prescribed area of a parking facility. This document specifies performance requirements for the operation functions, the environmental conditions within parking facilities where automated vehicle operation is performed, and the test procedures to verify the performance…