Rechercher

1 Scope 1.1 Applicable equipment 1.1.1 Specific heaters This Standard applies to newly produced, direct-fired and indirect-fired construction heaters, hereinafter referred to as heaters, constructed entirely of new, unused parts and materials and primarily intended for temporary use in heating buildings or structures under construction, alteration, or repair. Products of combustion generated…

1 Scope 1.1 This Standard covers terrazzo, concrete, composite stone, and natural stone plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings of these fixtures. 1.2 This Standard covers the following plumbing fixtures: a) bathtubs and combination tub/showers; b) lavatories; c) shower bases and shower stalls; and d) sinks: i) bar…

1 Scope 1.1 This Standard covers aluminum and copper plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings of these fixtures. 1.2 This Standard covers the following plumbing fixtures: (a) bathtubs and combination tub/showers; (b) lavatories; (c) shower bases and shower stalls; and (d) sinks: (i) bar sinks; (ii) kitchen sinks; (iii)…

1 Scope 1.1 Inclusions This Standard covers mechanical requirements of construction, marking, and type testing requirements for oil buffers and elastomeric buffers intended to be installed in passenger and freight elevators in accordance with ASME A17.1/CSA B44. 1.2 Exclusions This Standard does not cover spring buffers or electrical components as part of the buffer assemblies. 1.3 Dual…

1 Domaine d’application 1.1 Inclusions Cette norme couvre les exigences mécaniques de construction, de marquage et d’essai de type pour les amortisseurs à l’huile et les amortisseurs en élastomère destinés à être installés dans les ascenseurs de passagers et de marchandises conformément à ASME A17.1/CSA B44. 1.2 Exclusions Cette norme ne traite pas des amortisseurs à ressort ni des composants…

1 Scope 1.1 This Standard applies to deadfront indoor enclosed and outdoor enclosed assemblies of switchgear devices such as a) switches; b) interrupting devices; c) air circuit breakers; d) power circuit breakers; and e) control, metering, protective, and regulating equipment with associated interconnections and supporting structures. 1.2 This Standard covers equipment with a…

1 Scope 1.1 This Standard applies to extra-low-voltage landscape lighting systems and associated components that are intended for cord-connected, direct plug-in, or permanent connection to a branch circuit of not more than 150 volts-to-ground in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard only covers extra-low-voltage landscape lighting systems where the maximum…

1 Scope This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of all kinds of electrical heating appliances used for livestock rearing and breeding, such as: heat-radiating appliances, electrical sittinghens, incubators, chicken breeding units and heating plates for animals, the rated voltage of the appliances being not more than 250 V for single-…

1 Scope 1.1 Inclusions This Standard applies to the following electrically driven, mechanical, vapour compression-type systems: a) factory-made commercial and industrial unitary air-cooled air conditioners and heat pumps rated above 19 kW (65 000 Btu/h) cooling capacity at standard rating conditions for both single- and three-phase electrical power supplies; b) factory-made commercial and…

Scope This standard provides specifications for and operating characteristics of non-integral electronic drivers (power supplies) for LED devices, arrays, or systems intended for general lighting applications, including indoor and outdoor, as well as specific cases such as power over ethernet (PoE), and luminaires or lighting systems assembled with two or more LED drivers. In the future, it may…