Rechercher

Scope 1.1 This Standard specifies test methods and performance criteria for determining the efficiency of package furnaces. 1.2 This Standard applies to package furnaces using a three-phase power supply with input rates less than or equal to 2930 kW (10 000 000 Btu/h). 1.3 This Standard applies to package furnaces using a single-phase power supply with input rates greater than or…

Scope 1.1 This Standard specifies requirements for the design, construction, initial inspection and testing, marking, periodic inspection and testing, and repair of UN pressure receptacles and multiple-element gas containers (MEGCs) for the transport of dangerous goods. Annex A specifies the regulatory requirements for the conformity assessment system and registration requirements for…

Scope 1.1 This Standard specifies requirements for the selection, use, handling, and filling of UN pressure receptacles and multiple-element gas containers for the transport of dangerous goods included in Class 2, gases. 1.2 In CSA Standards, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard;…

Scope 1.1 This Standard specifies minimum requirements for the design, construction, installation, and operation of lifts that are to be specifically used by persons with physical disabilities travelling between fixed points of a building or structure, with a view to safeguarding against risk of accidents associated with the operation of such equipment. 1.2 This Standard addresses…

This National Standard of Canada is based on International Standard IEC 60335-2-79:2002. 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of high pressure cleaners for household, industrial and commercial use having a pressure not less than 2,5 MPa and not more than 25 MPa and with an input to the drive for the high pressure pump not…

This National Standard of Canada is based on International Standard IEC 60384-14:2005. Scope This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz.

Preface The primary objective of this handbook is to provide both novice and experienced quality practitioners with a concise, user-friendly guide to understanding and implementing the requirements of the ISO 9001 quality management standard. The ISO 9000 family of standards has undergone three revisions. Initially published in 1987, ISO 9001 was revised in 1994, 2000, and, most recently, in…

This National Standard of Canada is based on International Standard ISO 11135-1:2007. Scope This part of ISO 11135 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices. NOTE 1 Although the scope of this part of ISO 11135 is limited to medical devices, it specifies requirements and provides guidance that…

This National Standard of Canada is equivalent to International Standard ISO 15883-2:2006. 1 Scope This part of ISO 15883 specifies particular requirements for washer-disinfectors (WD) that are intended for use for the cleaning and thermal disinfection, in a single operating cycle, of re-usable medical devices such as surgical instruments, anaesthetic equipment, bowls, dishes and receivers,…

This National Standard of Canada is equivalent to International Standard ISO/TS 15883-5:2005. 1 Scope This Technical Specification includes the test soils and methods that can be used to demonstrate the cleaning efficacy of washer-disinfectors (WD) according to the ISO 15883 series of standards. The inclusion of the test soils and methods in this Technical Specification does not indicate…