Stationary source emissions — Greenhouse gases — Part 1: Calibration of automated measuring systems
ISO 14385-1:2014 specifies the procedures for establishing quality assurance for automated measuring systems (AMS) installed on industrial plants for the determination of the concentration of greenhouse gases in flue and waste gas and other flue gas parameters.
ISO 14385-1:2014 specifies a procedure to calibrate the AMS and determine the variability of the measured values obtained by an AMS,…
Stationary source emissions — Greenhouse gases — Part 2: Ongoing quality control of automated measur...
ISO 14385:2014 specifies procedures for establishing quality assurance for automated measuring systems (AMS) installed on industrial plants for the determination of the concentration of greenhouse gases in flue and waste gas and other flue gas parameters.
ISO 14385:2014 specifies the following:
? a procedure to maintain and demonstrate the required quality of the measurement results during the…
Information technology - Security techniques - Information security for supplier relationships - Par...
ISO/IEC 27036-2:2014 specifies fundamental information security requirements for defining, implementing, operating, monitoring, reviewing, maintaining and improving supplier and acquirer relationships.
These requirements cover any procurement and supply of products and services, such as manufacturing or assembly, business process procurement, software and hardware components, knowledge process…
Acoustics — Laboratory measurement of the reduction of transmitted impact noise by floor coverings o...
ISO 16251-1:2014 specifies a laboratory measurement method to determine the improvement of impact sound insulation by a floor covering when laid on a standard concrete floor mock-up and excited by a standard tapping machine. The method is restricted to soft, flexible floor coverings, which transmit impact sound mainly "locally" into the floor, i.e. through the area close to the points…
Acoustique — Mesurage en laboratoire de la réduction de la transmission du bruit de choc par les rev...
L'ISO 16251-1 :2014 spécifie une méthode de mesure en laboratoire permettant de déterminer l'amélioration de l'isolation aux bruits de choc d'un revêtement de sol mis en oeuvre sur un plancher de référence normalisé en béton, lorsqu'il est excité par une machine à chocs normalisée. La méthode est limitée aux revêtements de sol souples, flexibles, dont la transmission par…
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures -...
IEC 61300-3-47:2014 describes a procedure to measure the end face geometry of a spherically polished ferrule or connector. Within this standard the words "ferrule" and "connector" can be used interchangeably.<br />
Keywords: end face geometry, spherically polished ferrule or connector
Laine — Méthode de détermination de l'extrait dichlorométhanique dans un ruban de laine peignée
L'ISO 3074 :2014 spécifie une méthode de détermination de l'extrait dichlorométhanique présent dans un ruban de laine peignée. Son utilisation peut être étendue à la laine sous d'autres formes.
Il convient de faire remarquer que l'extraction au dichlorométhane dans les conditions prescrites n'élimine pas complètement toute la matière grasse présente dans un échantillon de…
Wool — Determination of dichloromethane-soluble matter in combed sliver
ISO 3074:2014 specifies a method for determining the dichloromethane-soluble matter in combed wool sliver. Its use can be extended to wool in other forms.
It should be recognized that extraction with dichloromethane under the prescribed conditions does not completely remove all the fatty material present in a sample of wool. A further amount, possibly material of similar character, will usually…
